How Long of Frame Channel is Needed to Install Titan Model 6 Actuator
Question:
I have to grind off old actuator and sway bartto install the new one I bought from you. length of 3 tube required on trailer to install Mdl 6 Titan actuator Thx
asked by: Robert G
0
Expert Reply:
The mounting flange length of the Titan Model 6 actuators is 9-1/2 inches and the additional length the master cylinder adds to that is 6 inches so you'd want to have around 16 inches of frame channel to install a Titan Model 6 actuator like the part # T4079200 that you referenced.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Zinc-Plated Brake Actuator - Drum - 2-5/16" Ball - Bolt On - 8,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Agricultural
- Construction
- Marine
- Travel Trailer
- Utility Trailer
- Bolt-On
- 8000 lbs GTW
- 2-5/16 Inch Ball Coupler
- Drum Brakes
- No Lockout
- Dexter
more information >
Continue Researching
- Q&A: Replacement for Titan Model 6 Trailer Brake Actuator
- Q&A: What is the Mounting Hole Spacing on Titan Zinc-Plated Brake Actuator T4747220
- Q&A: Do I Clean Or Replace The Master Cylinder on a Titan Model 6 Actuator That is Full of Rust?
- Q&A: Recommended Replacement Strap for Shelby 5408 Winch
- Q&A: Shelby 5408B Winch Replacement Recommendation
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Recommended Replacement For A MagneTek 6345A Power Center Converter
- Q&A: Replacement Converter for 45 Amp Magnetek 6345
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Hand Winches
- Article: Most Popular Wheel Bearings
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Slipper Spring Trailer Suspension System Review