Wiring Installation Kit To Properly Disconnect and Reconnect Wiring
Question:
how do you disconnect it ... to connect a new one ........... only way I see is to cut the wires ...... then when I reconnect ..... its now not water proof any more
asked by: John C
Helpful Expert Reply:
The best way to keep Over 80" LED Trailer Light Kit # TLL160RK waterproof is to use heat shrink butt connectors. Since this assembly uses 20 gauge wire you will need # DW05743-10 to make the best connection. The butt connectors will help insulate the wire connection to keep the connection as dry as possible.
Products Referenced in This Question
Optronics LED Combination Trailer Tail Lights - Submersible - 40 Diodes - Driver and Passenger Side
- Trailer Lights
- Tail Lights
- License Plate
- Rear Clearance
- Rear Reflector
- Side Marker
- Side Reflector
- Stop/Turn/Tail
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 8L x 3W Inch
- Red
- Optronics
more information >
Product Page this Question was Asked From
Deka Heat Shrink Butt Connector - 22-18 Gauge - Nylon Insulation - Red - Qty 10
- Wiring
- Wire Connectors
- Butt Connectors
- 22-18 Gauge
- Deka
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Lighting Requirements
- Article: Dealer Spotlight - Toucan's Auto Repair
- Article: Trailer Wiring Diagrams
- Article: Best Hitch Cargo Carriers
- Q&A: Looking For Replacement Marker Light SAE A PC2 DOT 17 For A 2022 Surveyor Legend
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Taillights, Wiring and 7-Way Connector for Car Hauler
- Q&A: Wire Gauge for the Dexter Nev-R-Adjust Electric Trailer Brake Assembly
- Q&A: Butt Connector Recommendation for Wiring up Brake Assemblies on Trailer
- Q&A: What Gauge Wire Should I Use to Install (2) # TLL44FB at the Back of My Super Duty?
- Article: Curt Echo Full Review
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Buyers Products Hitch Plate Dimensions
- Q&A: How to Replace a 4-Way Trailer Connector with 8 Wires