Dimensions of the Hopkins Endurance 7-Way Trailer Connector Socket # HM48480

Question

Question:

Im looking at item number HM48480. Could you give me the dimensions of the item? If you look at the page for item PK11893, there is a photo that shows the dimensions of the size of the item as well as the distance between the holes. That is what Im needing for item HM48480.

asked by: Frank

0

Expert Reply:

The Hopkins Endurance 7-Way Trailer Connector Socket, # HM48480, measures 2-3/4 inches wide and 3 inches tall. I have attached a picture to illustrate these measurements as well as the distance between the mounting holes.

expert reply by: Leah S

0

click to enlarge

Answer 1

Since you said your RV step motor is part number 9551 you'd want the motor part #LC379147.

view full answer...

Answer 2

The reverse light circuit on most vehicles usually have a max amperage draw of around 5 amps. The amperage is usually limited by the gauge of the wire used on the circuit. The recommended wire size for the reverse light pin on the Pollak Black…

view full answer...

Answer 3

Standard trailer wiring circuits on 7-ways like the part #C58155 and #PK12706 are rated for up to 40 amps so if you wanted to use a 7-way like this to power a horn that is rated for 13 amps you certainly could.

view full answer...

Answer 4

First I recommend trying to determine exactly where the air is leaking from on your Air Lift LoadLifter 5000 Ultimate Air Helper Springs #AL88289 with Upgrade Kit #AL52301. The -4 AN Elbow Fitting #AL52RV could leak in one of 3 places. The AN/tapered…

view full answer...

Answer 5

There are several items you might want to try using for removal of corrosion in your 7-way trailer connector, like part #HM48480. White Vinegar A wedge shaped, slip on pencil eraser or art gum eraser Pipe cleaners PB Blaster If the corrosion is…

view full answer...

Answer 6

Hey Kevin, it sounds like you are looking for the Hopkins part #HM45MV that you referenced. This will replace your current 7-way with a 7-way that has a 4-way built into the side of it.

view full answer...

Answer 7

I took a look at your account and it looks like you purchased the Cargo Bag for Carpod Hitch Mounted Cargo part #M2202 with the 23x47 Carpod Walled Cargo Carrier for 2" Hitches - Steel part #M2205. The cargo bag is designed to go inside of the…

view full answer...

Answer 8

The SportRack Cargo Carrier for 2" Hitches #SR9851 has a shipping weight of 67-lbs. This figure includes the packaging so the actual net weight of the cargo carrier itself is approximately 63-lbs. The 2-inch Class III hitch receivers we offer…

view full answer...

Answer 9

Since the Lippert Hydrauluic Landing Gear Feet are 12 inch in diameter and round the correct Snappads would be the part #SP74FR4.

view full answer...

Answer 10

Yes it is possible to add a separate amber directional light to the trailer using part #118158. Most trailers use a 2-wire system. One wire for the running lights on the trailer and the other wire is for the brake/turn signals. You can use the…

view full answer...

Answer 11

The Optronics 7-Way Connector - Trailer End #A7WCB will handle 8-gauge wires on the positive and negative connectors. If you want the same gauge wire on the vehicle side, I recommend the Hopkins Endurance 7-Way Trailer Connector Socket - Vehicle End…

view full answer...

Dimensions of the Hopkins Endurance 7-Way Trailer Connector Socket # HM48480

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching