Can Trailer Lights be Install on Jeep Wrangler JK Using Warrior Products Steel Tail Light Mounts

Updated 11/10/2014 | Published 11/08/2014

Products Featured in This Question

GloLight LED Trailer Clearance or Side Marker Light - Submersible - 6 Diodes - Round - Amber Lens

(115)

$16.14

Rubber Grommet for 4" Round Trailer Lights - PVC

(229)

$4.44

2" Round Grommet - Flush Mount - Open Back

(289)

$3.64

Uni-Lite LED Clearance and Side Marker Light w Grommet - Submersible - 2 Diodes - Amber Lens

(819)

$7.61

GloLight Halo LED Trailer Light - Brake, Turn, Tail - Submersible - Round - Red

(425)

$26.46

Question:

Hi, can you please let me know if I can install the following LEDs on the Steel Tail Light from Warrior Products -steel-tail-lights-with-stop-reverse-light-cut-outs-pair-and jk-steel-tail-lights 1 STL101RMB with A45GB rubber grommet - used as a tail/stop tail light 2 MCL155AB with A54GB rubber grommet - used as a turn light and 3 MCL11AKB - used as a turn light. Thank you, and I look forward to hearing from you.

asked by: Shree S

Expert Reply:

To install light # STL101RMB with grommet # A45GB the hole would have to be 4-1/2 inches. And to install light # MCL155AB with grommet # A54GB the hole has to be 2-5/16 inches in diameter.

I am not sure where you would put light # MCL11AKB on those mounts you mentioned but it requires an 11/16 inch diameter hole. This last light is a clearance or side marker light. It is not DOT approved as a turn signal.

Since we do not carry the mounts you are looking at you would have to go by the dimensions of the holes needed to install the lights to determine fit.