Shackle Bolt Recommendation for the CE Smith Front Hanger Bracket # CE14016G
Published 11/06/2014
Products Featured in This Question
Question:
Which spring eye bolt do I want to buy with this bracket? Thanks,
asked by: Guy
0
Expert Reply:
The diameter of the holes that are used for installing leaf springs is 9/16 of an inch. A bolt like the part # 166081 would work as it is 3 inches long and the bracket is 2-1/4 inches wide.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
CE Smith Front Hanger Bracket for Trailer Slipper Springs - Galvanized Steel - Bolt On - Qty 1
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Snowmobile Trailer
- Slipper Springs - 1-3/4 Inch
- 9/16 Inch Diameter
- 2-1/4 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- CE Smith
more information >
Continue Researching
- Q&A: Leaf Spring Replacement for 21-1/2 Spring on 2001 StarCraft Camper
- Q&A: Should Trailer Leaf Springs Have Shackles on Front and Back
- Q&A: How To Properly Measure Slipper Springs For Your Trailer's Leaf Sping Suspension
- Q&A: Roadmaster Comfort Ride Leaf Spring Suspension Kit for CrossRoads Elevation TF3612
- Q&A: Replacement Axle-Less Trailer Suspension Square Axle 49.5 Hub Face and 38.5 Spring Center
- Q&A: Gooseneck Pin Box for 2023 Keystone Montana 3231CK
- Q&A: Troubleshooting Slanted Equalizer on Unloaded 7K Cargo Trailer
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Double-Eye Trailer Suspension System Review
- Article: Slipper Spring Trailer Suspension System Review
- Article: Where to Position the Trailer Axle?
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Tire Sizing