Choosing Replacement Fender for Tracker Marine Boat Trailer

Updated 07/16/2025 | Published 07/19/2018

Question:

I see that the F008583 might work on my trailer that has my 1996 Pro DV 17.6 Tracker. How do I measure it to be sure and what hardware do I need to mount the Fenders 2?

asked by: William P

Expert Reply:

The Fulton Single Axle Trailer Fender # F008583 referenced in your question may work well as a replacement on your 1996 Tracker Boat Trailer. This particular fender is designed for single axle trailers like yours that are equipped with 13 inch tires like what you have. Its overall dimensions are 9 inches wide, 40 inches long, and 12 inches tall. The front and rear mounting bracket slot is 4 inches long. I have attached an image with these and a few other dimensions labeled that you can take a look at. I simply recommend comparing these measurements to those on your existing fender to see if this will be a suitable replacement with your existing hardware.

If you aren't able to use your current hardware, your best bet is to simply obtain the needed parts from a local hardware store. Because trailers are so different the mounting methods differ as well so it's hard to say exactly what you will need.

I have attached a short video demonstration on this fender that you can also check out.

expert reply by: Chris R

click to enlarge

Kathy S.

5/1/2020

Need to replace the wooden fender back to my 2001 trackerstar trailer. Lost one and the other one carpet is shot. Do you have pre cut fender back preferably with carpet !

Chris R.

5/3/2020

We do have a couple fender back assemblies available with the 12" # 12FB-32R and 10-1/2" # 10FB-32R, although they are not carpeted.

Mike

7/15/2025

The picture that u presented is exactly what I need… The mounting bolts are two on each side like in the picture…I need two fenders.

Chris R.

7/15/2025

@Mike Hey Mike, do you mean the dimension image is exactly what you need? If so, the part # F008583 is what matches up to those measurements. If you're needing something different just let me know.

Mike

7/15/2025

@ChrisR Look at the picture of the fender…zoom in on the right side…you will notice two bolts to secure the fender to the trailer…that is what I need…do u have that fender? I need two a left and right.

Chris R.

7/16/2025

@Mike Ah, gotcha. It doesn't look like we have an exact replacement for that style, but somethin a bit closer would be the etrailer # HP93RR. It uses a few mounting holes on the step platform like the one pictures, but it's three holes instead of two. You might be able to make this work.