Size of Mounting Bolts for CE Smith Front Hanger Bracket # CE14016G
Published 11/06/2014
Question:
What size mounting bolts? 7/16? Grade? Galvanized? Thanks,
asked by: Guy L
0
Expert Reply:
The size of bolts for the CE Smith Front Hanger Bracket, part # CE14016G, are as follows:
The 2 top holes on the ends take 7/16" diameter bolts.
The center top hole takes 1/2" in diameter bolts.
The lower spring eye holes take 9/16" diameter bolts.
I have included a picture showing these measurements for you. I recommend using grade 5 galvanized bolts.
expert reply by:
Chris O
0
click to enlarge
Product Page this Question was Asked From
CE Smith Front Hanger Bracket for Trailer Slipper Springs - Galvanized Steel - Bolt On - Qty 1
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Snowmobile Trailer
- Slipper Springs - 1-3/4 Inch
- 9/16 Inch Diameter
- 2-1/4 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- CE Smith
more information >
Continue Researching
- Q&A: Should Trailer Leaf Springs Have Shackles on Front and Back
- Q&A: Roadmaster Comfort Ride Leaf Spring Suspension Kit for CrossRoads Elevation TF3612
- Q&A: Gooseneck Pin Box for 2023 Keystone Montana 3231CK
- Q&A: Troubleshooting Slanted Equalizer on Unloaded 7K Cargo Trailer
- Q&A: What Size Axles Are Used With the Timken Bearing Kit TMK96ZR
- Q&A: Cross Reference a Replacement for a TCM 21334 TB Grease Seal
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Wiring Diagrams
- Q&A: Can MORryde X-Factor and Roadmaster Comfort Ride Systems be Installed Together?
- Article: Double-Eye Trailer Suspension System Review
- Article: Slipper Spring Trailer Suspension System Review
- Article: Where to Position the Trailer Axle?
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Tire Sizing