Long Locking Hitch Pin Needed for Class V Trailer Hitch on a Chevy K2500 Pickup Truck
Updated 09/15/2014 | Published 09/13/2014
Products Featured in This Question
Question:
I need a locking hitch-pin that fits the Chevrolet K2500 with the OEM Class V hitch. The usable area of the shaft must be approximately 3 3/4inch long. Will this fit this application? If not do you carry a locking hitch-pin that fits? It has to be 5/8inch in order to fit through the adapter.
asked by: Jason
Expert Reply:
You might be able to use Blue Ox pin # BX88212 which measures 4-3/8 inches between the ends so it will work.
The best way to measure to ensure the clearance needed is to use a tape measure that is small enough to fit through the hitch pin holes. Then measure the outside to outside width of the hitch that way.
Product Page this Question was Asked From
Rapid Hitch Trailer Hitch Lock and Adjustment Pin Lock Set for 2" and 2-1/2" Hitches
- Trailer Hitch Lock
- Standard Pin Lock
- Keyed Unique
- Fits 2-1/2 Inch Hitch
- Flush Pin
- 3-5/16 Inch Span
- Andersen
more information >
Continue Researching
- Q&A: Looking For Way To Transport E-Bikes While Flat Towing 2019 Jeep Wrangler Sahara JLU
- Q&A: Availability of B&W Tow & Stow Pintle Hook
- Q&A: Availability of B&W Tow & Stow Pintle Hook for Ford F-350 With 3" Receiver
- Q&A: Can 2.5" Weigh Safe Pintle Hitch Be Used In Rise Position?
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Availability of Heat Strip or Heat Pump for Furrion Chill Cube RV AC
- Q&A: Replacement 4.80-12 Trailer Wheel and Tire for Jet Ski Trailer
- Q&A: Replacement Dust Cover Needed For An Andersen Rapid Hitch Trailer Hitch Lock
- Article: Rooftop Cargo Carriers
- Article: Steel vs. Aluminum Ball Mounts
- Article: How to Choose the Right Trailer Hitch Class
- Article: Which Hitches are Made in the USA
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)