bing tracking image
Q & A Icon

Complete Towing Setup for a 2027 Toyota Grand Highlander With Tow-Pro Link  

Updated 11/19/2026 | Published 11/18/2026

Question:

I have a 2027 Toyota Grand Highlander XLE with the gas engine. It doesn't have a hitch or trailer wiring, and I need to tow a small camper with electric brakes. I like the Redarc Tow-Pro Link since I don't want to install a brake controller under the dash. Can I use it without a factory 7-way, and what all would I need?

0

Expert Reply:

Hey Brian! Yes, you can use the Redarc Tow-Pro Link # RED57AR on your 2027 Toyota Grand Highlander without a factory 7-way. I recommend the following setup:

-Curt Trailer Hitch Receiver # C26VV

-Curt Powered Tail Light Converter # C59236

-etrailer 7-Way Installation Kit # e556GR

-Redarc Tow-Pro Link Brake Controller # RED57AR

-etrailer Adjustable 2-Ball Mount # e66PR

The Curt hitch gives you a 2" receiver, and the converter adds a 4-way connection for your trailer lights. The # e556GR then adds a powered 7-way with the detachable USCAR connection needed for the Tow-Pro Link.

The Link mounts near the rear of your vehicle, so you won't have to run brake controller wiring into the cab or install a permanent control knob on your dash. You can control the trailer brakes using the included wireless remote or via the app.

The adjustable ball mount makes it easy to get your camper level. If you measure from the ground to the bottom of your camper's coupler when it's level, we can also find the right fixed ball mount for your setup.

What kind of camper are you towing?

expert reply by:
0
Robin H
Curt Trailer Hitch
Curt Trailer Hitch
(click to enlarge)
Curt Trailer Hitch
Curt Trailer Hitch
(click to enlarge)
Brian profile picture

Brian

11/19/2026

It's a Forest River pop-up camper with a 2" coupler. I measured about 17" from the ground to the bottom of the coupler with the camper level. Would a fixed ball mount work instead?

Robin H. profile picture
Etrailer Expert

Robin H.

11/19/2026

@Brian I recommend the etrailer Ball Mount # e38NR. We measured 15" to the top of the receiver when we installed the Curt hitch, so with your camper's 17" coupler height, you need about 2" of rise. The # e38NR has a 2-3/4" rise and comes with the 2" ball already installed, so it should work well for your setup.

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>