Trailer Hitch And Wiring For A 2026 Toyota Grand Highlander Hybrid MAX Limited

Updated 11/13/2026 | Published 11/12/2026

Products Featured in This Question

etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"

(57)

$271.03

Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector

(2211)

$78.50

Question:

Hi - Please recommend a hitch and wiring for: 2026 Toyota Grand Highlander HYBRID MAX Limited trim. - I understand the one for the Hybrid is different from the regular version. Thank you.

asked by: Christopher B

Expert Reply:

Hi Christopher!

For your 2026 Toyota Grand Highlander Hybrid MAX Limited, I recommend starting with the etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2" # e69ZV. We have actually installed this hitch on your exact vehicle, so I can 100% say it will fit. I included an image of it installed as well as that install video to help when you go to put it on.

The wiring is where the Hybrid MAX comes into play a bit more. We have seen issues with the plug and play wiring harness and the Hybrid vehicles, so I recommend going with the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector # C59236. This is a hardwired option, but we know it works and will be the better option for your vehicle.

What are you going to be towing once all this is installed?

expert reply by: Lazer S

etrailer Hitch e69ZV On 26 Grand Highlander HybridMax Limited
(click to enlarge)

Christopher B.

11/13/2026

Towing a single axle boat trailer with 4 pin wiring - so this should be fine.

Lazer S.

11/13/2026

@ChristopherB Nice! There is one more thing you will need if you don't already have one. That being a ball mount. When we installed the hitch, we found it to sit 15" when measured from the ground to the inside top of the receiver opening. You will need to measure from the ground to the bottom of the coupler on the trailer (when it's as level as possible) and then compare those two numbers to figure out what drop or rise you will need for the ball mount. As an example, with the hitch being 15" and say your coupler measures 18", you would be looking for a ball mount that has 3" of rise. Then you just need to know if that coupler is for a 1-7/8" ball or 2" ball. That should be stamped into the top of the coupler. If you can get me the height of your coupler and the ball size needed, I can definitely find you a couple good options for that as well! ^___^