bing tracking image
Q & A Icon

How Do I Replace a Seized Knob on My Yakima EXO SwingBase?  

Updated 11/19/2026 | Published 11/12/2026

Question:

I am trying to replace the knob assembly on a Yakima EXO Base. Your directions indicate the knob should be turned all the way in clockwise AND the lock button in the middle position. Unfortunately, I am not able to turn the knob clockwise or counter clockwise and the lock button or pin will not move - completely seized up. Given these scenarios, how do i replace the knob assembly?

0

Expert Reply:

Hey Randy, thanks for reaching out! Since the knob and locking pin on your Yakima EXO SwingBase are completely seized, I'd start by making sure the lock is in the unlocked position, then apply some penetrating lubricant around the knob shaft and locking pin. Let it soak for a bit, then gently work the knob back and forth while pressing the locking pin to see if you can free everything up. Once the knob turns and the pin moves freely, tighten the knob fully clockwise, center the locking pin, and follow the replacement instructions to remove the old assembly and install the new one. Avoid forcing the knob or pin, since that could damage the SwingBase mechanism.

If lubricating the mechanism doesn't free it up, I'd suggest reaching out directly to Yakima to see about a warranty claim.

Has the knob gradually become harder to turn, or did it suddenly lock up?

expert reply by:
0
Jesse M
Randy N. profile picture

Randy N.

11/12/2026

Thank you so much for the feedback. I did apply a spray called Kroil to the knob, locking pin, the exposed spring area, and the screw which holds the assembly in place. Let it sit for more than 24 hours and nothing changed. All is still locked up. Next step will be more Kroil, let it sit and then try a hammer drill in the one screw holding everything in place. Pretty sure the screw requires a T30 but I may be wrong.

Jesse M. profile picture
Etrailer Expert

Jesse M.

11/13/2026

@RandyN Ok gotcha! Sorry to hear the spray didn't do the trick. It's worth another shot but I would definitely encourage you to reach out to Yakima about a warranty claim before you start hammering or drilling anything.
Randall profile picture

Randall

11/19/2026

@JesseM - thanks you so much for the feedback. Your support has been fantastic!! I did reach out to Yakima and they are sending me an entirely new YAKIMA EXO Base System for my truck. Thank you again for everything!!
Jesse M. profile picture
Etrailer Expert

Jesse M.

11/19/2026

@Randall Oh awesome! Glad to hear they took care of you. You know where to find me if you ever need anything else!

Product Page this Question was Asked From