Is an Offset Gooseneck Ball Needed with MORryde GooseTech on a 2018 Silverado 3500 Short Bed?
Updated 11/09/2026 | Published 11/07/2026 >
Products Featured in This Question
Question:
I am interested in upgrading to the Mr37MT for my 2017 Grand Design Reflection 337, I have a 2018 Silverado 3500 with the 6.6foot bed with factory gooseneck setup. Some say I need an offset ball for this and others say I dont. Do you have any data that actually confirms which is correct.
asked by: Rick L
Expert Reply:
Good morning Rick. I believe you're referring to the MORryde GooseTech # MR37MV.
Your 2017 Reflection 337RLS has a tapered front cap designed to improve turning clearance, so you may not need an offset ball. However, I can't guarantee that without a couple of measurements.
You can check this at home in just a few minutes with a tape measure:
Measure from the center of your truck's factory gooseneck ball socket to the back of the cab.
Measure the width of your trailer's front cap at its widest point.
Subtract half the trailer width from your first measurement. Ideally, you'd want at least 4" of clearance. The attached diagram shows how to measure.
If clearance is tight, the Gen-Y 5" Offset Gooseneck Ball # GY23XR is an option for your Silverado. This works with the MORryde or really any gooseneck setup and pushes it back 5" for more turning clearance.
Can you send me those two measurements? I'll help you figure out whether the offset is necessary!
Product Page this Question was Asked From
MORryde GooseTech 5th Wheel to Gooseneck Pin Box for 11.5K to 14K Trailers w/ Lippert 1621
- 5th Wheel Gooseneck Adapter
- Adapts Trailer
- 5th Wheel Trailer to Gooseneck Hitch
- No Extra Clearance
- 24000 lbs
- Replaces Pin Box
- Shock Absorbing
- Lippert 1621
- MORryde
more information >
Continue Researching
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Which is Better Cushioned Pin Box to Gooseneck Adapter a MORryde Goosetec or a B and W
- Q&A: Best Trailer Hitch For 1993 Chevy C1500 Short Bed
- Q&A: What is Length from Mounting Bolts to Ball Center of B and W 5th Wheel to Gooseneck Adapter
- Q&A: Recommended Lock for MORryde GooseTech 5th Wheel to Gooseneck Pin Box
- Q&A: Dimensions of B&W 5th Wheel to Gooseneck Pin Box for Lippert 1621 BW73RV
- Q&A: Which B&W Fifth Wheel to Gooseneck Adapter Is Best For Towing My Trailer?
- Q&A: Does MORryde GooseTech Have Vertical Movement
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Article: Gooseneck to 5th Wheel Adapters
- Article: Best 5th Wheel to Gooseneck Adapters (2023)
- Article: Ram Trailer Tow Prep Package
- Article: Converting Your RV Water Heater to Tankless
- Article: Which Hitches are Made in the USA




Rick L.
11/9/2026
Thank you Andrew. Ok, center of factory ball to tailgate is 53” and width of nose is 97”. Doing the math, I believe I need the offset. My other concern would be tailgate clearance of the hitch box.