Is the Lippert Hydraulic Pump # LC99DX the Correct Replacement for a 3-Valve, 4-Jack Leveling System
Published 10/15/2026 >
Question:
is this a replacement for Lippert Hydraulic Pump Assembly for Motorized, 3-Valve, 4-Jack Leveling System 390350
asked by: Jim R
0
Expert Reply:
Hello Jim,
Thanks for writing in.
Yes, since you have the Lippert 3-valve, 4-jack hydraulic leveling system, the Replacement Hydraulic Pump # LC99DX is the correct replacement for your original Lippert 390350.
It comes with a 1.2-gallon reservoir, 4-bank manifold, and pre-wired wiring harness, so you will have everything needed to replace your existing pump assembly.
Did it completely go out, or are you having other issues?
expert reply by:
Kate F
0
Product Page this Question was Asked From
Replacement Hydraulic Pump for Lippert Leveling Systems - 1.2 Gal - 4 Bank - Pre-Wired
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hydraulic Parts
- Pumps
- Lippert
more information >
Continue Researching
- Q&A: Parts Needed To Install Demco Hijacker Autoslide With Underbed Rails On 2017 Silverado 2500 Diesel
- Q&A: Lug Nut Cover for 2006 Ford F-53
- Q&A: How to Install a Brake Controller on a 2018 Toyota Tundra
- Q&A: Replacing A Lippert A-Frame Jack For A Side-Mount Swivel Tongue Jack
- Q&A: Replacement A-Frame Jack For Atwood Mobile Product Jack On Trailer With 2" Diameter Mounting Hole
- Q&A: Troubleshooting Slide-Out Function Where Solenoid Clicks But Doesnt Move Motor
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: The Best RV Battery Chargers
- Q&A: No Power to Front Jack of Lippert Ground Control 3.0 4-Point Set

