Lippert TireLinc System for Factory-Prepped RV

Updated 10/19/2026 | Published 10/14/2026

Question:

I have a 2022 Sonic by Venture RV 220VML that is pre-wired for a Lippert TireLinc monitoring system. I only have the mounting base already installed in camper What do I need to use system? Signal booster and wheel sensors 4 sensors/dual axle. I would like to monitor either on my phone or through Android Auto on my 23 Nissan Frontier. thanks in advance for your reply.

asked by: Jonathan R

Expert Reply:

Hey Jonathan!

Thanks for reaching out. The best setup for outfitting your 2022 Sonic travel trailer with the TireLinc monitoring system is the Tire Linc Pro TPMS # LC77VC. This setup includes 4 sensors, will allow you to monitor with Android Auto (or Apple CarPlay for others reading) in your Frontier, and boost your signal with the included repeater. The repeater will connect directly with the factory-installed wiring and you'll just need to install the sensors with the included tools.

From there, your road trips will be noticeably safer and you can monitor tire pressure, as well as temperature to avoid too much heat build-up. The best part is that the system notifies you of any potential issues like excess heat and high or low tire pressure. The sensors run on CR1632 which I've found is easy to find in most convenience store battery sections, so no worries about having to replace the full sensor after the battery finally gives out.

Are you prepping for an upcoming trip? Is this camper new to you or are you just upgrading components?

expert reply by: Jerry B

Jonathan R.

10/15/2026

We aren't new to camping. This unit is new to us. Just wanting to get it all set up for us to travel as safe and worry free as we can. Thank you for the information. I will be doing something soon. Jon

Jonathan R.

10/16/2026

So I see this TPMS #LC77VC. It has two wires (a red and a white). I haven't studied too closely, but my base is already mounted in the camper. Don't I just plug the signal booster in and attach it? Thanks, Jon

Jerry B.

10/19/2026

@JonathanR You're exactly right! Since your Sonic already has the TireLinc mounting base installed and wired up, you can just snap the repeater from the # LC77VC into that base. No additional wiring is needed. The red and white wires you're seeing belong to the extra mounting base included with the kit. You won't need that part since Venture RV already took care of the installation for you! From there, just install the four tire sensors and pair everything through the Lippert app, and you'll be ready to monitor your tires from your phone or through Android Auto.