What are the Dimensions of the Quick Fist 3" Clamp?
Updated 10/10/2026 | Published 10/09/2026
Products Featured in This Question
Question:
Could you please provide the dimensions of this part? I’m designing something and believe it would be a perfect fit if the dimensions are suitable. I would appreciate it if you could share the dimensional details. Thank you!
asked by: Syed
Expert Reply:
Hi Syed,
I went out to the warehouse to measure it for you and the Quick Fist 3" Clamp part # QF50050 is 4 1/2" long, 1 3/8" wide, and 5 1/8" tall (measured to the top point of the triangular bump at the top). I've included a diagram showing my measurements for reference so you can see where I measured from. I'm not sure what you're planning to use the clamp with but it only fits objects that are 2 3/4" to 3 1/4" in diameter and supports up to 50lbs. The clamp shouldn't be used anywhere with temperatures that exceed 180 degrees as it'll affect the integrity of the rubber.
What are you designing that you want to use the clamp for?
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Quick Fist 3" Clamp - 2-3/4" to 3-1/4" Inner Diameter - Rubber - 50 lbs
- Tie Down Straps
- Trailer
- Truck Bed
- Tie Down Clamp
- 0 - 175 lbs
- Quick Fist
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is 72" Wide the Bracket or Sofa Measurement on the Thomas Payne RV Jackknife Sofa TP88KR?
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Is The Lippert Telescoping Ladder Receiver Bracket Sold Separately
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: Replacement Power Converter For A Parallax/MagneTek 6300 Series Model 6345
- Q&A: Can the Tekonsha P3 Trailer Brake Controller be Reset
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Q&A: Replacement AC for Dometic Duo-Therm 3107541.009
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
Syed
10/9/2026
Thank you for prompt response, I am designing a safety pin which needs to be hold by rubber clamp with the diameter of 3". this is the I get so far which is perfect fit for the project.