How To Use The Adhesive In The RecEnergy Membrane Plus RV Roof Replacement Kit

Published 10/08/2026

Question:

I purchased one of your EPDM roofing kits and saw that there are no instructions for the membrane adhesive on the can. Is the any way to find the application instructions anywhere? Recenergy universal membrane adhesive.

asked by: Thomas G

Expert Reply:

Hi Thomas!

Sorry about that not being included, but I can definitely help with that. After rolling out the EPDM Membrane (on your roof) from the RecEnergy Membrane Plus RV Roof Replacement Kit - 42' Long - White # PM32VR you got to check the fit, you will follow the steps I have listed below:

1 - Fold back one half of the membrane.
2 - Stir the water-based acrylic adhesive and apply it evenly to the exposed substrate using a 9-inch short-nap paint roller.
3 - Allow the adhesive to tack up/dry for approximately 20 minutes.
4 - Slowly roll and lay the EPDM membrane into the adhesive.
5 - Use a push broom, roller, or squeegee to smooth out the membrane and push out any air bubbles or wrinkles.
6 - Repeat the gluing and smoothing process for the second half of the roof.

Though not for this specific kit, we do have an FAQ about replacing the roof membrane and I have that included if you wanted to check it out. Might find it helpful. ^___^

What are you working on?