Best Electric Over Hydraulic Brake Actuator for Tandem Axle Boat Trailer
Updated 10/01/2026 | Published 09/27/2026 >
Products Featured in This Question
Question:
I have a tandem axle boat trailer, 24 boat, approximately 6800 lbs boat/trailer. The trailer has hydraulic surge brakes. I pull the boat with a yukon XL 6.2L that has a factory brake controller. Im interested in converting to electric-over hydraulic. I was looking at the dexter units, but which unit is the best quality one you sell for my setup? Also is the installation a DIY job?
asked by: Jeffrey M
Expert Reply:
Hey Jeffrey! The best and most reliable electric-over-hydraulic actuator we carry is the Hydrastar. Our installers have consistently found these to have a quick response time and excellent reliability compared to other options.
If your boat trailer has disc brakes, which is likely the case, I recommend the Hydrastar # HS381-9067. If you have drum brakes, you can use the Hydrastar # HS381-9066 instead. Both include the actuator, 7-way with junction box, and breakaway kit needed for the conversion. You can continue to use your existing brake lines as long as they're in good condition.
This is also a very DIY-friendly conversion. You'll be mounting and wiring the Hydrastar, connecting your existing brake lines, and either locking out or replacing the existing surge coupler. The existing wiring on your trailer will tie into the junction box for the lights and you'll have your brake output connection as well.
Any big trips coming up with your boat once you make the conversion?
Product Page this Question was Asked From
Hydrastar Marine Electric Over Hydraulic Actuator w/ Breakaway and 7-Way RV Harness - 1,600 psi
- Brake Actuator
- Electric-Hydraulic Brake Actuator
- Boat Trailer
- Travel Trailer
- Disc Brakes
- Hydrastar
more information >
Continue Researching
- Q&A: How To Install The Plug-And-Play Hydrastar Vented Marine Electric Over Hydraulic Actuator
- Q&A: What is Best Electric Over Hydraulic Actuator for 2023 Mastercraft Boat Trailer
- Q&A: Parts Needed To Switch From Surge Brakes To An Electric-Over-Hydraulic Actuator
- Q&A: Best Brake Controller Recommendation for Electric Over Hydraulic Trailer Brakes
- Q&A: Is There A 1.5" Hitch To 2" Hitch Adapter?
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Replacement Actuator for Tie Down TDE LP8000
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Choose a Trailer Hitch Coupler
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Trailer Brakes Not Working? Troubleshooting Guide



David C.
9/30/2026
Our boats are about the same size. I used the Hydrastar HS381-9067 and could no be happier with the results. It has worked flawlessly with both my ‘23 and ‘26 ram 2500. Gone is the dragging when you take off after a stop. The best part is have brakes when backing down steep gravel boat ramps. The installation was straight forward and simple. The hardest part was drilling and tapping the trailer frame. The total installation took me about 2 hours. I highly recommend this unit to anyone interested in changing to electric over hydraulic brakes. The only additional things I bought was a 7 wire coiled connector ( my wiring was short) and a 12” braided stainless steel brake line with a 90 degree fitting on one end as my brake lines were installed in the trailer tubing and in a bad spot.