Looking for Replacement Valve Body for 1.5 inch Waste Valve on RV  

We have #T1003-7VP which is the older style 3” seal kit for valves made prior to 2000. But if you have a newer unit, you need part number #T1003-9VP that is the newer style 3” seal kit for current valves made after 2000.

The Double RV Waste Valves #T18C that you referenced is a very common valve on RVs like yours. Theres a good chance this is what you need. This slips over a 3 inch pipe on the bigger siade and the smaller side slips into the 1-1/2 inch pip.

Thanks for supporting a local business Christopher! So long as your 2012 Chevrolet Silverado is a 1500 and you need a class IV hitch, the Curt item #14301 is going to be the best option. It has a 2" receiver with a 10,000 lbs towing capacity and…

That's a great question, John! Yes, you can use the etrailer Replacement Fabric #e26QV in place of the Solera Replacement Fabric #LCV000334415. They are both made to work on the same size awning, so the fabric will be the same size and will…

Hey Silas, starting in 2000 did Valterra move from the old style valve to the new style. So that means for your 2020 Montana High Country the correct seal kit would be the part #T1003-9VP as you for sure have the new style.

Hello Michael, Thanks for writing in! Yes, you can recreate the setup you have on your 2014 Forest River R-Pod. You won't find it as one single 1-1/2" to 3" bayonet adapter, but you can put it together with two fittings. For your…

To replace your Dometic Thermostat you will want to use the Replacement Single Zone Thermostat for Dometic RV Air Conditioners item #DMC79FR you were looking at. It does indeed control both the furnace and the air conditioner. I have attached a…

Hey Denny, based on the serial number of your roof vent lid the correct replacement would be the part #BVE0108-03 which is the same smoke color you have now.

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…