Replacement Red Side Marker Lens for Tractor Supply Utility Trailer Light
Updated 06/21/2026 | Published 06/17/2026 >
Products Featured in This Question
Question:
Hello...I am looking for a Trailer Tail-light side lens cover...all I need is the red lens cover because I have one that is missing... the other one that I measured is 2 1/4inch wide and 3inch tall...Just so that you know kind of what I am talking about and IF you have one or know of a place where I can get one, I will explain it here...So going by the part above RD65RR and what I need is the side lens cover that is to the right or left of the Tail-Light cover...It looks to be glued in because I see no screw hole or screw on the other side....Sorry for being a bit vague but I think you will know what I mean...Thanks...This is for a tow behind trailer that I bought at Tractor Supply...
asked by: Harold
Expert Reply:
Hi Harold,
Thanks for reaching out. I think I understand exactly which lens you're referring to. Based on your description, it sounds like you're looking for the small red side marker lens that sits next to the main tail light lens and appears to be snapped or bonded into the housing rather than attached with visible screws.
I can't say with confidence that we have the exact replacement lens for your trailer, but the closest match I was able to find is the Replacement Side Marker Lens for Peterson Tail Lights, part # 444-151R. It measures 2-3/4 inches long by 2 inches tall, which is slightly smaller than the 3 inch by 2-1/4 inch dimensions you provided, but it otherwise matches your description well since it does not use visible screw holes and is designed as a replacement side marker lens.
Since replacement lenses can vary quite a bit between manufacturers, especially on utility trailers sold through Tractor Supply, the best way to make sure we're getting the right part would be to see a photo of the light assembly and the missing lens area. Unfortunately, it's becoming more common for manufacturers to offer only the complete light assembly rather than individual replacement lenses, so finding an exact lens match isn't always as straightforward as it used to be. If you can send me a photo of your light, I'd be happy to take a closer look and help identify the best replacement option before you spend money on the wrong part. My email is [email protected]
f you're able to send a picture, I'd be happy to take a closer look and see if we can identify it. Also, what do you usually haul with your Tractor Supply tow behind trailer?
Product Page this Question was Asked From
RV Designer Rear Trailer Light Kit w/ Tail Lights, Side Marker Lights
- Trailer Lights
- Clearance Lights
- Tail Lights
- Brake/Tail/Turn/Backup
- Rectangle
- Surface Mount
- Non-Submersible Lights
- 4-3/4L x 4-1/2W Inch
- Amber
- Red
- White
- RV Designer
more information >
Continue Researching
- Q&A: Will AirBedz Rear Seat Air Mattress Fit 2022 Nissan Altima SV
- Q&A: Timken Replacement Bearings and Brake Assemblies for 2021 Dutchmen Voltage 3845
- Q&A: Are Shackles Necessary For A Single Axle Utility Trailer?
- Q&A: Recommended Hub Face Dimensions for 48 Inch Wide Trailer Frame for 3500 lb Axle
- Q&A: Recommended Temporary Brake Lights For 10 Foot Box Truck
- Q&A: What Gauge Wires are Used Epicord 7-way Connector part # e99010
- Q&A: Electric Trailer Jack for 2026 Coleman 13R
- Article: How to Measure a Trailer Axle
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams




Harold
6/19/2026
Hello and thank you for the reply… I did get a hold of Carry-On Trailers since I found out that that is the brand of trailer that I have… So I emailed them with the same question and they said they do not sell that particular lens cover and I would have to get a whole brand new taillight set up… But I will send you the pictures anyways that I took of both sides of the tail light and one side is missing the lens cover and one has the cover… I am not sure as how to include a photo or the pictures that I took in this email because I’m not getting that option to do so??