Looking For Replacement Nylon Washer For Dexter DX7.5L A-60 Brake Actuator
Updated 05/06/2026 | Published 04/27/2026
Question:
for a Dexter DX7.5L A-60 Brake Actuator. Whats the part number for the nylon washer that sits next to the C clip on the bar that slides when brake is actuated? The Nylon washers are visible from the outside and one on each side.
asked by: Oliver L
Expert Reply:
Hey Oliver, thanks for reaching out. We do have a replacement nylon washer for the Dexter DX7.5L A-60 actuator. For that you can use the following:
- Replacement Nylon Washer for Dexter Model 6 and 10 Actuators # T1861900
If yours are worn out, replacing those will definitely help the actuator slide more smoothly.
What kind of trailer do you have?
(click to enlarge)
Product Page this Question was Asked From
Replacement Nylon Washer for Dexter Model 6 and 10 Actuators
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Hardware
- Washers
- Dexter
more information >
Continue Researching
- Q&A: Installation Direction of Leaf Springs Does the Band around the Spring Pack Go Forward
- Q&A: Recommended Spring Eye Diameter Bolt for 9/16 Inch Hole on my Boat Trailers Leaf Spring
- Q&A: Tips For Removing Stuck Master Cylinder Cap On A Dexter T4750820 Actuator
- Article: Best Boat Trailer Jacks
- Q&A: Replacing Rubber Bearing T1020900 and Nylon Washer T1861900 on a Model 10 Actuator
- Article: Boat Trailer Guides: Which are the Best?
- Q&A: Recommended Guide-Ons That Stick Out 24 Inches From Either Side Of Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: How to bleed the brakes on a surge brake actuator on boat trailer
- Q&A: Solution for Needing New Master Cylinder 1027100 and Damper for Titan Model 6 Actuator
Oliver L.
5/5/2026
I’m not sure what part that replace on the actuator. But the part number for the tapered washer is 005-168-00. Doesn’t look like you sell it though.