How to Test Tekonsha T-One Power Converter on 2010 Jeep Patriot
Updated 04/28/2026 | Published 04/25/2026 >
Question:
i have a tekonsha control module on my patriot , i only have power on the right turn signal, how can i test it to see if it is bad
asked by: DAVID R
Expert Reply:
Hey David! What you need to do is take your circuit tester and check for power running into the power converter. If you have power coming in, but not going out (aside from right turn signal) the module is bad. I would also double check the ground connection since that could cause this problem. Make sure it is secure on a clean, bare metal surface.
If the converter is bad, you can replace the entire wiring harness with the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C56333.
What do you usually tow with your Patriot?
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Hitch and 4-Way Wiring for a 2017 Jeep Patriot
- Q&A: 2015 Jeep Patriot Trailer Hitch and Wiring Recommendation
- Q&A: Can You Convert 4 Way Plug To Work With Trailer Brakes?
- Q&A: Troubleshooting Wiring Harness Issues With Curt C56333 On 2017 Jeep Patriot
- Q&A: Will The Peterson M540 Light Kit Fit A Bracket With 2-1/4" of Head Room?
- Q&A: Best 7-Way Wiring Harness For 2017 Honda Pilot
- Q&A: What is Needed to Install a 7-Way on a 2008 Chrysler Town & Country
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Which Hitches are Made in the USA
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Hitch Installation Tips
- Article: Roof Rack Information



David R.
4/28/2026
Thank you