Looking for Replacement Leaf Springs for 2022 Keystone Alpine 3650RL
Updated 03/12/2026 | Published 03/11/2026 >
Products Featured in This Question
Question:
Can direct to a replacement double eye leaf Spring for my 2022 ALPINE 3650RL by keystone. I believe I have Dexter 7000lb axles. If possible, I’d like to go with 7 leafs rather than the six I have. Thanks
asked by: William K
Expert Reply:
Hey William, could I get the length of your current springs when there isn't a load on them? With that info I can see what replacement springs you'd need. The two lengths we have are the part # e64SR which is 24-7/8 inches and the part # TRU52FR which is 25-1/4 inches. These are all 6 leaf as we don't have any 7's for this capacity.
Product Page this Question was Asked From
Wet Equalizer Bolt with Locknut and Grease Zerk for Double-Eye Springs - 3" Long
- Trailer Suspension Parts
- Suspension Bolts
- Camper
- Car Hauler
- Utility Trailer
- 9/16 Inch Diameter
- 2-5/16 Inch Long
- Redline
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Wet Bolt Recommendation For the Roadmaster Comfort Ride Leaf Spring Suspension Kit
- Q&A: What Roadmaster Comfort Ride System Should I Use for my 2025 East to West AHARA?
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Replacement Leaf Spring for a Dexter 072-079-01 Leaf Spring
- Q&A: Do Bronze Bushings Need to be Used with MORryde X Factor and Roadmaster Comfort Ride
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Will The Kodiak Disc Brake Kit K2HR10A11RERR Fit An AL-KO 10k #99 Spindle?
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Recommended Replacement Weld on Trailer Jack for a Phoenix Boat
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: Recommended 26" Long 4-Leaf Double-Eye Spring for 4,000 lbs Trailer Axles
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Double-Eye Trailer Suspension System Review



Cory
3/12/2026
If it is the same length and diameter it should be fine