Recommended Bearing Covers for a Homemade Boat Trailer
Updated 03/12/2026 | Published 03/04/2026
Products Featured in This Question
Question:
I have an older homemade boat trailer that the bearing covers of 1.98 inches are just a bit too small for. The 1.98 inch appears to be the same size as what I need to cover. Do you have any options for something that would fit this bearing size...just over 2 inches is what I think it needs to be
asked by: Douglas W
Expert Reply:
Hey Doug. We have two Bearing Buddy Bras that are just over 2". They're the item # BB19B which has an outer diameter of 2-1/8" and the item # BB17B that has an outer diameter of 2".
If you're needing an actual set of Bearing Buddys and not just the bra. We have a couple of options that will fit a bit larger than a 2" hub bore.
2.047" Hub Bore - Bearing Buddy Bearing Protectors - Model 2047SS - Stainless Steel (Pair) item # BB2047SS
2.080" Hub Bore - Bearing Buddy Bearing Protectors - Model 2047SS - Stainless Steel (Pair) item # BB2080SS
The Bearing Buddy Bearing Protectors - Model 1980-SS - Stainless Steel (Pair) item # BB84SR are what's recommended for a 1.980 hub bore.
Do you have a part number off of one of your hubs? I can look up what Bearing Buddy you need if you could put that information below where it says Add Comment.
(click to enlarge)
Product Page this Question was Asked From
Replacement Bearing Buddy Bras - Model 19B - (Pair)
- Accessories and Parts
- Trailer Bearings Races Seals Caps
- Dust Caps
- Bearing Buddy
more information >
Continue Researching
- Q&A: Does the 1/4" ID Lippert Hydraulic Hose LC52AX Come w/ Fittings?
- Q&A: How Wide is the Curt Weight Distribution Shank C17132?
- Q&A: Replacement Trailer Leaf Spring Solution for Dexter 072-098-00
- Q&A: Replacement Leaf Spring Recommendation for a Dexter Axle 072-098-00 Rated for 7,000 lb Axle
- Q&A: Replacement Hose Fittings for Lippert Leveling Systems
- Q&A: What Size O-Ring is Needed for Lippert Replacement End Fitting for Hydraulic Hose
- Q&A: Availability of a Trailer Coupler that Fits a 3-1/2 Inch Wide Tongue
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Printable Trailer Bolt Hole Pattern Template
T. R.
3/10/2026
I bought these and I'm very happy with them. They are for my boat trailer which is also very old. Just take your time to make sure you get the correct size.