How to Add a 7-Way Connector to a 2024 Toyota Sienna

Updated 02/25/2026 | Published 02/22/2026

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(409)

$224.85

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(59)

$84.72

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3553)

$118.67

Question:

looking for a 4th gen Toyota Sienna wiring harness to tow my small camper with a 7 pin connector...not seeing anything? May buy the woodland edition for the better suspension, it has a 4 pin installed, or possibly a different trim without a tow package. Appreciate any suggestions.

asked by: Suzy E

Expert Reply:

Hey Suzie. To add a 7-Way connector to a 4th generation Toyota Sienna you'll need a 4-way wiring harness like item # C53VV and the Universal Installation Kit item # ETBC7. There is no custom fit 7-way harness and you have to have a 4-way harness installed as well.

The Curt item # C53VV is a custom fit harness that plugs into a factory connector at the rear of your Sienna. It will provide you with a 4-way connector.

The Universal Installation Kit item # ETBC7 includes a pre-wired 7- and 4-way trailer connector that mounts easily at the rear of your Sienna with an included bracket. This kit is designed for use on a vehicle with an existing 4-way flat trailer connector and plugs directly into it. You'll then need to connect a line to your battery and your brake controller.

I've linked a couple of installation videos below so you can see how to get these wiring harnesses installed.

What kind of camper do you have?

You can add this information, along with any other questions you have, where it says Add Comment.