Could Bright Way Trailer Breakaway Kit # 3802339 Be Used to Power Interior Lights
Updated 03/04/2026 | Published 02/06/2026 >
Question:
I have an enclosed cargo trailer with a current working brakeawy system. Do you think it would be possible to add this one as well, utilizing the battery charging circuits but using the output as a brake locker, but wired to internal trailer lights? End game, leave the woring brakeawy as is and add this one to operate lights in the trailer.
asked by: Tommy
Expert Reply:
Hey Tommy, the Bright Way Trailer Breakaway Kit # 3802339 that you referenced could be used for what you are looking for as it's basically just a 5 amp hour battery in a battery box that's wired to be charged from a 7-way trailer connector. But you should note it's only a 5 amp battery so hopefully the lights are LED and there's not a ton of them.
Product Page this Question was Asked From
Bright Way Trailer Breakaway Kit with 0.5-Amp Charger and 5 Ah Battery
- Trailer Breakaway Kit
- Kit with Charger
- Single-Axle
- Tandem-Axle
- Tester Not Included
- Electric
- Battery Included
- 5 Ah
- 48 Inch Long
- Bright Way
more information >
Continue Researching
- Search Results: 12 volt breakaway battery
- Shop: Bright Way Push-to-Test Trailer Breakaway Kit with 1-Amp Charger and 5 Ah Battery - Top Load
- Shop: Bright Way Trailer Breakaway Kit with Charger, LED Tester, and 5 Ah Battery - Side Load
- Shop: Brightway ICU Trailer Breakaway Kit w/ Charger, LED Tester, and 5 Ah Battery - Side Load
- Search Results: rm690
- Shop: Curt Soft Trac I Trailer Breakaway Kit with Charger and 5 Ah Battery - Side Load
- Video: An In-Depth Look at the Replacement 12V 5 Ah Battery for Bright Way Trailer Breakaway Kits
- Video: Bright Way Push-to-Test Trailer Breakaway Kit Review and Installation 3802308
- Q&A: Does Brightway ICU Trailer Breakaway Kit Come With Diodes
- Q&A: Correct Way to Wire Trailer Breakaway Kit
- Q&A: Is Diode Needed to Prevent Trailer Battery from Backfeeding to Breakaway System
- Q&A: Can a Diode Be Installed on Trailer Brake Controller Output Wire to Prevent Back Feed?
- Q&A: Can a Trailer Break Away Battery be Charged from the 7-Way Trailer Connector
- Q&A: Do Trailer Breakaway Kits Have Diodes to Prevent Backfeeding
- Q&A: Will The Breakaway Switch Draw Power When Disconnected From Tow Vehicle
- Shop: Bright Way Trailer Breakaway Kit with 0.5-Amp Charger and 5 Ah Battery
- Shop: Roadmaster Single Park Light Diode
- Search Results: trailer hitch
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Video: Installing the Curt Trailer Hitch Receiver on a 2025 Toyota RAV4
- Shop: Trailer Wiring
- Search Results: trailer wiring
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: trailer tires and wheels
- Article: Trailer Lighting Requirements
- Shop: Suspension Enhancement
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer


Jameson C.
3/4/2026
Hey Tommy, how did things go using the Bright Way breakaway kit to power your trailer lights? I'm curious if the 5‑amp battery gave you enough runtime with your LED setup. Your results could help others trying a similar wiring approach.