Where Is The Valterra RV Sewer Slip Hub with Flange T1005 Made
Updated 01/16/2026 | Published 01/15/2026
Question:
What is the country of origin for the Flange, 3 in. Slip Hub, T1005 ?
asked by: Rebecca H
0
Expert Reply:
Hello Rebecca, thanks for reaching out. Valterra products like the Valterra RV Sewer Slip Hub with Flange # T1005 are made in Mexico.
expert reply by:
Jesse M
0
T1005
(click to enlarge)
(click to enlarge)
Dant
1/16/2026
Flange worked perfectly saved a lot of hassle to replumb tank outlets
Product Page this Question was Asked From
Valterra RV Sewer Slip Hub with Flange - 3"
- RV Sewer Hose Fittings
- Sewer Seals and Gaskets
- Slip Hubs
- Hub
- Sewer Pipe to Waste Valve
- 3 Inch Diameter
- Valterra
more information >
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Comparing Valterra And LaSalle Bristol Cable Actuated Gate Valves
- Q&A: Electric Waste Valve Compatibility to Replace Cable Actuated Valves
- Q&A: Can Gate Valves Be Replaced Without Cutting And Gluing In New Fittings
- Q&A: Is There an Adjustment on LaSalle Bristol RV Waste Valve to Allow it to Close Tighter
- Q&A: Furrion RV Fireplace to Replace WF-40S Titan Flame 40 inch Fireplace
- Q&A: Complete Flat Towing Setup for a 2025 Ford Ranger XLT 4X4
- Q&A: How To Remove Furrion Oven Rack From Furrion Range Oven
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Trailer Wiring Diagrams
- Article: How to Wire an Electric Winch
- Article: Best Bike Racks for Electric Bikes
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
Steve
1/16/2026
The Valterra flange I installed is working well. I put it in about 2 years ago and have not had any problems..