Will Square Direct Weld Jack Match Crank Ratio of Jack on RawMax Dump Trailer
Updated 01/27/2026 | Published 01/01/2026
Question:
Need to replace one of the two 10K side wide trailer jack on a RawMax dump trailer. Will the RAM model listed on your website match the crack ratio? Or is the crack ratio standard on all the 10K side wind jacks? Thanks
asked by: Ben V
Expert Reply:
Hi Ben; I believe you're asking about the crank ratio, or gear ratio, for the Square Direct Weld Jack # e66FV. Ram didn't give us this information but I can try to reach out and get it.
There is no standard, so you will also need to identify the jack you currently have to see if it matches. You do want to make sure they match. If you are unable to identify it, and if it the other one is pretty worn out, it might be a good idea to go ahead and replace both.
(click to enlarge)
Product Page this Question was Asked From
Square Direct Weld Trailer Jack - Drop Leg w/ Spring - Sidewind - 12-3/8" Lift - 10,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- 5th Wheel Trailer
- Gooseneck Trailer
- Side-Mount Jacks
- Sidewind Jack
- 9001 - 10000 lbs
- Manual Jack
- 26 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Continue Researching
- Q&A: Can etrailer Square Direct Weld Jack Replace Buyers Products 0091410
- Q&A: Replacement Parts Available for the RAM Trailer Jack Part # TJD-7000S
- Q&A: Recommended 12,000 lbs Capacity Weld On Square Jack w/a 28-3/4" Lift
- Q&A: Instructions for Disassembling a 12,000 lb Bulldog Jack
- Q&A: Replacement Parts for Pro Series 12000 Trailer Jack
- Article: Trailer Wiring Diagrams
- Q&A: Does etrailer Sell The Rubber Bumper For Trailers D4-96 ?
- Q&A: Replacement Gear Kit Instructions and Diagram for Ram 12,000 Series
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure a Trailer Axle
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Dealer Spotlight - Hamilton Trailer Repair
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
Robin H.
1/27/2026
Hey Ben, were you able to find out if the crank ratio on your current jack matches the RAM model? Knowing what you discovered could help others trying to pair jacks on similar dump trailers.