Will The Curt Front Hitch C87FR Fit A 2024 Ram 1500 Bighorn With Active Air Dam?
Updated 12/26/2025 | Published 12/24/2025 >
Question:
Hi, Im after a front hitch mount for my 2024 Ram 1500 Bighorn 4x4 with a Hemi. Does this work on a 2024 with the active air dam? Thanks
asked by: Richard
Expert Reply:
Hi Richard!
The Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2" # C87FR will indeed work with the active air dam on your 2024 Ram 1500 Bighorn. I included a picture where you can actually see that (look in the lower left corner). So you are good to go!
What are you going to be using the front hitch for?

D M.
12/26/2025
Just to follow up I use the from hitch for my canoe loader, bike rack and have a screw pin D shackle in case I get stuck , you will have to remove your front tow hooks for the hitch needs that space.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 500 lbs Vert Load
- 5000 lbs GTW
- 9000 lbs Line Pull
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Air Lift Ride Control Air Helper Springs - Rear Axle
- Shop: Suspension Enhancement
- Q&A: Why Do Tow Hooks Need To Be Removed In Order To Install A Front-Mounted Trailer Hitch
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Camper Tie-Downs for 2020 Ram 1500 With Factory Air Suspension
- Q&A: What is the Receiver Height Requirement for a Detail K2 Snow Plow
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Can a Different Hub Assembly Be Installed to Allow Larger Tires to be Used on Pop-Up Camper
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Article: Stability Control for Heavy Duty Vehicles
- Q&A: Do You Carry a Class 4 Hitch for My 2024 Dodge Ram 1500 Tradesman 3.6 L?
- Article: Curt Echo Full Review
- Q&A: Can A Hitch Extender Be Used With A Front Mount Trailer Hitch To Park A Travel Trailer
- Q&A: Replacement Pin for Solera Power Awning Drive Head
- Article: Trailer Maintenance Schedule



D M.
12/26/2025
The hitch does not interfere with the active air dam The support is high above the shaft One thing to consider you will need to cut out the front stationary air deflector ( the one connected to the bottom of the bumper) for the hitch tube to fit also the hitch pin hole will be behind the deflector meaning you will need to crawl under the truck to place your pin through I cut a slot on each side of the hitch in the deflector so I can install the pin without crawling under the truck. My truck is a 2 wheel drive and low to the ground I don’t see the cut outs , you have a 4 wheeler that sets up higher you need to consider the cut outs may show and if that is acceptable to you. Note the cutouts do not cause it to whistle or flap in the wind