What Kind Of Mounting Hardware Is Needed To Mount The Go Power Automatic Transfer Switch?
Updated 01/19/2026 | Published 12/19/2025
Question:
what size fastener is used for the 4 mounting holes on the box?
asked by: Brandon C
0
Expert Reply:
Hey Brandon,
The Go Power Automatic Transfer Switch, # 342GPTS, uses standard #8 or #10 screws. These are just standard size screws #8 being thinner and #10 being more heavy duty for better security. These can be found at any hardware store, or loose screw bucket if you have one.
What kind of trailer are you looking to install this on?
expert reply by:
Nick S
0
Product Page this Question was Asked From
Go Power Automatic Transfer Switch with Quick Connect Cables - Plastic Case - 30 Amp - 120V
- RV Transfer Switch
- 30 Amp
- 120V
- Shore Power to Inverter
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Locking Pins for Weigh Safe Aero Adjustable Ball Mount
- Q&A: Will The 55A WF86FR Converter Power Center Charge My RV Batteries Faster Than The 40A Model?
- Q&A: Using the PD52 50 Amp Transfer Switch with 30 Amp Service
- Q&A: Testing a Vehicle Side 7-Way Trailer Connector for Proper Function
- Q&A: Using Go Power Automatic Transfer Switch to Switch Between Shore Power and Solar Power
- Q&A: How Do Furrion Chill HE AC Units Drain Built Up Condensation
- Q&A: How Do Furrion Rooftop AC Units Drain Condensation Build Up
- Article: Trailer Wiring Diagrams
- Article: Demco Vehicle-Specific Base Plates
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Wire an Electric Winch
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: No Missteps Here: Best Camper and RV Steps (2022)
- Article: Does Solar Panel Type Really Matter?
Nick S.
1/19/2026
Hey Brandon, how did things go with mounting the Go Power transfer switch using the #8 or #10 screws? Your update could make it easier for the next person working on a similar setup.