Can Connectors of Lippert Motor Harness part # LC238991 be Replaced
Updated 12/29/2025 | Published 12/02/2025
Question:
Can I replace the ends if needed? if so does it change the wiring resistance?
asked by: Dave M
0
Expert Reply:
Hey Dave, yes you could remove the ends of the Lippert Motor Harness part # LC238991 and it wouldn't affect the resistance of it at all.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Lippert Replacement Motor Harness for RV In-Wall Slide-Out - 25' Long
- RV Slide Out Parts
- Motor Parts
- Wiring Harness
- Lippert In-Wall RV Slide-Out Systems
- Lippert
more information >
Continue Researching
- Q&A: Is 23 inches from Spring Seat to Hub Face Too Long
- Q&A: CAN Bus Data Cable To Go With Replacement Touch Panel Assembly LC75UD
- Q&A: What To Do If There Are Parts Missing To Connect The Lippert OneControl ConnectAnywhere Cellular Kit
- Q&A: Replacement For 1510000236 Slide-Out Controller
- Q&A: Troubleshooting A Slide Out Box That Stops Before Fully Sealing Closed
- Q&A: Wiring For Lippert For Lippert Slide-Out Controller 13398-DO
- Q&A: Direct Replacement For The Lippert In-Wall Slide-Out Controller Part # 13398-C2
- Article: What Size Generator Do You Need to Run an RV Air Conditioner?
- Article: How to Service An RV Air Conditioner
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Gooseneck to 5th Wheel Adapters
- Article: How Many Batteries Do You Need to Run RV Air Conditioner?
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV
Jameson C.
12/29/2025
Hey Dave, how did things go after you replaced the ends on your Lippert motor harness? Your update could make it easier for the next person wondering about wiring resistance.