What Bearing Kit do I Need for My Small Foldable Trailer that Fits in the Corner of My Garage?
Updated 12/08/2025 | Published 11/13/2025
Products Featured in This Question
Question:
I need a full set of bearings, races and seals for two trailer hubs that go on a 1 trailer axle shaft. Not sure on the brand of the trailer but its one of those foldable stake side trailers that you can fold in half and roll into a corner of your garage.
asked by: Andrew K
Expert Reply:
Hello Andrew,
Sounds like you’ve got a pretty small trailer, so I would imagine the axle is on the lighter side. Most of the smaller folding trailers use a BT8 spindle, which is common on 2,000 pound axles.
You can either pull the bearings out to double check, or measure the spindle where the bearings sit. You should get 1" for both your inner and outer bearing, please refer to the attached image. It is best to measure with a Digital Caliper like # PTW80157.
If you find that you have a 1" straight spindle, the Bearing Kit for 1" BT8 Spindle, L44643 Inner/Outer Bearings, 34823 Seal # BK1-100 will be the correct kit for you. Don't forget to grab some bearing grease if you don't have any already. The # L11390 will get the job done.
After you measure your spindle, if it turns out not to be a 1" straight spindle, please let me know the measurements you get so I can find the right kit for you.
(click to enlarge)
Product Page this Question was Asked From
4" Carbon Fiber Digital Caliper
- Hand Tools
- Measuring and Layout Tools
- Digital Calipers
- Carbon Fiber
- Performance Tool
more information >
Continue Researching
- Q&A: Replacement Hub/Rotor for UFP 41030
- Q&A: Kodiac Disc Brake Kit Compatibility with UFP DB-42 Axle
- Q&A: Does The Dexter DX26XR Replace My DB-42 Calipers?
- Q&A: Replacement Brake Setup for Trailer with DB-42 Disc Brakes
- Q&A: How Can I Identify an Axle Without a Sticker?
- Q&A: Dimensions of CES38WR Spindle
- Q&A: Greasable Shackle Bolt that is 3-1/2 inch Long and 9/16 inch Diameter
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Lighting Requirements
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: What Do I Need To Tow A Trailer?
Andrew K.
12/8/2025
The spindles on my trailer are 1" inner and outer bearings. Thanks for the information on what bearing kits I need to purchase. I already have a digital caliper.