Will the B&B Top Rear Corner Trim Cover for RV Seam Work for Both Sides of the Trailer?
Published 11/05/2025
Question:
Will this part work on both left and right hand sides?
asked by: KAYSIE
0
Expert Reply:
Hey Kaysie, thanks for reaching out!
Yes, the B&B Top Rear Corner Trim Cover for RV Seam # BM65XR will work for both the left- and right-hand sides of the RV. Just make sure you don't use screws for the left side of the trailer for the right side and vice-versa (my attempt at humor...if it didn't work, please don't hold it against me).
Are both sides of the trailer in bad shape, or are you just needing one side and wanting to make sure you get the correct one?
expert reply by:
Jon G
0
Product Page this Question was Asked From
B&B Top Rear Corner Trim Cover for RV Seam - Black
- RV Trim
- Plastic Molding
- Black
- B and B Molders
more information >
Continue Researching
- Search Results: victron
- Shop: Victron Lynx Shunt VE.Can with Built-In Battery Monitor - M10
- Search Results: victron lynx
- Shop: Victron Lynx Power In Modular DC Busbar - 1,000 Amp
- Search Results: orion xs
- Shop: Victron MultiPlus-II Inverter Charger with 1 AC Input - 2,400 Watts - 50 Amps - 12V - UL Listed
- Shop: B&B Top Rear Corner Trim Cover for RV Seam - Black
- Video: Review of NOCO Interconnect Busbar NLX Lithium Battery - NOC29GR
- Video: Review of Victron Battery Connectors - Lynx Power In M10 Modular DC Busbar - VN36RR
- Shop: Victron Smart RV Battery Monitor with Bluetooth - Gray
- Search Results: lynx distributor
- Search Results: air bag
- Search Results: bmv~712
- Search Results: pacbrake air bag compressor kit
- Shop: Victron Lynx Distributor Modular DC Busbar - 1,000 Amp
- Shop: Victron MultiPlus-II Inverter Charger with 2 AC Outputs - 2,400 Watts - 50 Amps - 12V - UL Listed
- Q&A: Drain Hole Locations On A Furrion Roof Top AC Unit
- Q&A: Can a Higher Amp RV Converter Be Used for Replacement
- Video: Restore your trim to new. A look at how factory replacements are made.
- Video: Review of B and B Molders RV Trim - Plastic Molding - BM65XR
- Q&A: Looking for Corner Trim Piece for Forest River FR3 30DS
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Q&A: Which Victron Inverter Charger Is Best For Off-Grid Camper Van Build?
- Q&A: Replacement Pinion Spur Gear for Power Gear Slide Out on 2007 Fleetwood Providence
- Q&A: Troubleshooting Fogatti Tankless Water Heater With E3 Error Code After Replacing Water Flow Sensor
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
Kaysie
11/5/2025
Hahaha! Thank you for the information. We are replacing a roof membrane on a customers unit & the caps are cracked & broken. Also, the overall measurement from end to end are the 4 1/8" correct?