What Size Hole doe the Drive Shaft Clevis Pin would Go Through on the Lippert Venture Repair Kit?
Updated 10/30/2025 | Published 10/06/2025
Question:
What is the size of the hole in the drive shaft that the clevis pin would go thru to connect the cross shaft? Thanks!
asked by: Chris
Expert Reply:
Hello Chris,
The hole in the drive shaft where the clevis pin connects the cross shaft on the Lippert Venture Follow Leg Repair Kit for 5th Wheel RV Landing Gear # LC146060 is designed for a 3/8-inch diameter clevis pin. This is the standard size used across most Venture and Lippert landing gear systems, allowing the cross shaft to rotate smoothly and stay securely attached. If replacement hardware is needed, the Venture Pin Kit # LC146060 includes the correct 3/8-inch x 2-5/8-inch clevis pin, along with the matching snap and hair pins.
What kind of camper is this going on? Do you know what brand landing gear you have? If you are not sure, please be sure to send me any part numbers you can find, I am happy to cross reference them.
Product Page this Question was Asked From
Lippert Venture Follow Leg Repair Kit for 5th Wheel RV Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Schematic Diagram for Stromberg Carlson Lead Jack Repair Kit LG-146059
- Q&A: How to Find the Correct Replacement Lead Leg for 5th Wheel Landing Gear
- Q&A: Replacement Parts or Assembly for Landing Gear of 1998 Gulfstream Innsbrook
- Q&A: Availability of Repair Kits for Venture VMC940RB-216708 Lead and Follow Leg
- Q&A: Repair Kit for Venture VMC900R-651112 on 2021 Forest River Cherokee Wolf Pack 315PACK12
- Q&A: Comparing the Reese # RP500708 and Ultra-Fab Deluxe # UF17-943010 Landing Gear
- Q&A: Recommended Landing Gear Rebuild Kit For Landing Gear On 2005 Hitchhiker 34.5' 5th Wheel Trailer
- Article: Brake Controller Installation: Starting from Scratch
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Install an RV Awning From Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
Kate F.
10/30/2025
Hey Chris, did the 3/8-inch clevis pin fit the drive shaft on your landing gear the way you needed? Your update could make it easier for others working with the same Lippert Venture setup.