Is There An Adapter To Turn My 7 Way Into Easy Access To 12 Volts?
Updated 10/30/2025 | Published 10/05/2025 >
Question:
I just finished hooking up a 7 way connector for a car carrier trailer. Connector works perfectly. Is there any convenient way to access the 12 V from the connector to operate an electric wench located on the trailer?
asked by: Laurence P
Expert Reply:
Hey Laurence,
The only adapter I see out there that gives easy access to 12V is the Pollak 7-way to 12v outlet adapter # PK11896. This essentially converts your 7 way into a 12v outlet at the rear of the vehicle. One thing you want to make sure of is how much power your winch draws. This adapter is only rated to handle 20-30 amps of power draw. I know some winches that use more than that so I would double check that first.
Do you know what model winch/trailer you have?
Product Page this Question was Asked From
Pollak 7-Way to 12 Volt Power Outlet Adapter
- Custom Fit Vehicle Wiring
- Wiring Adapters
- Universal Fit
- 7 Blade
- Plug Only
- Pollak
more information >
Continue Researching
- Q&A: Availability of Adapter to Plug Into 7-Way and Provide 110V AC Power Outlet
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Does The Curt RockerBall C29FR Come Pre-Greased?
- Q&A: Recommended Battery for a 12,000 Lb. Electric Car Trailer Winch
- Q&A: Recommended Adapter to Plug Portable Air Pump into Trailer Connector
- Article: Trailer Wiring Diagrams
- Q&A: Width of ComeUp Cable Tensioner for DV-12, DV-15, and DV-18 Winches # CU881087
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Q&A: Replacement 10 Inch 5-on-5 Bolt Pattern Brake Drums for Old Car Trailer
- Q&A: How to Power Small 12V Air Compressor Using Trailer Connector
- Article: How to Measure for Motorhome Steps
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: Trailer Maintenance Schedule
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)


Nick S.
10/30/2025
Hey Laurence, did you get a chance to try the Pollak 7-way to 12V adapter with your trailer winch? It’d be great to hear if the power output was enough for your setup. Your update could make it easier for others running similar winches.