Recommended Tail Light Mounting Bracket w/ 2" Spacing for Mounting Holes
Updated 09/12/2025 | Published 08/30/2025
Products Featured in This Question
Question:
I need something like this but need the holes to be 2in apart, not 3. Do you have a bracket like this? Steel Mounting Bracket for Peterson Stud Mount Tail Lights - Surface Mount - Black Powder Coat Part Number: 510-9
asked by: Isaac
Expert Reply:
Hey Isaac. 3" is the total width of the Steel Mounting Bracket for Peterson Stud Mount Tail Lights item # 510-9. The mounting holes are spaced 2" and 2-3/8" apart. I have attached a diagram below so you can see all the measurements.
This bracket is designed to be used with lights like the Peterson Round Trailer Tail Light item # 432000 for left hand or item # 431800 for right hand.
What kind of lights are you installing?
(click to enlarge)
Product Page this Question was Asked From
Steel Mounting Bracket for Peterson Stud Mount Tail Lights - Surface Mount - Black Powder Coat
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Brackets
- Black
- Peterson
more information >
Continue Researching
- Q&A: Can 4-Flat Plug Be Cut Off Of Blue Ox Plug-In Tow Bar Wiring Kit BLU92HR
- Q&A: Why Would 7-Way Adapter 20142 Only Work for a Few Hours
- Q&A: Troubleshooting Trailer Tire Wear on the Outside Edge of the Tire
- Q&A: Determining Correct Replacement Leaf Spring For Trailer W/ 3000lb Axles and 27" Long Springs
- Q&A: How to Run a Charge Line to a 4-Way Connector
- Article: How Level Should a Tow Bar Be When Flat Towing
- Q&A: Does Hopkins Tow Bar Harness part # HM56009 Fit 2018 Ford F-150
- Q&A: Recommended Flat Towing Set Up for a 2016 Kia Soul w/ a Manual Transmission
- Article: Trailer Wiring Diagrams
- Article: Hand Winches
- Article: Best Boat Trailer Jacks
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
Jerred H.
9/12/2025
Hey Isaac, did the Steel Mounting Bracket with the 2-inch hole spacing work for your setup? I'm curious to know how it turned out, as it could help others with similar needs.