Trying to Track Down Hub/Drums for Older Fleetwood Prowler
Updated 08/15/2025 | Published 07/21/2025
Question:
I have a 74 fleet wood prowler single Elle trailer that the brakes are locking up. I think it may be bad drums…. The drum markings say it’s a Fayette 9230 W-1 it’s a 4 lug Assy . I can’t seem to find this , is there a new replacement?
asked by: Sherrill R
Expert Reply:
Hey Sherrill, hub components that old are really hard to track down. It wasn't until basically the late 90's things got more or less standardized. We don't have anything that cross references with the info you listed but there is small chance if you pull a hub and get me the bearing numbers or the spindle dimensions where the bearings ride I could find something that would work. Also if you have the axle capacity that would work too.
Product Page this Question was Asked From
4" Carbon Fiber Digital Caliper
- Hand Tools
- Measuring and Layout Tools
- Digital Calipers
- Carbon Fiber
- Performance Tool
more information >
Continue Researching
- Q&A: Recommended Bearing Kit for a 3,500 lbs Axle on a Boat Trailer
- Q&A: How to Determine the Replacement Hubs for a 2002 Magic Tilt Trailer
- Q&A: Kodiac Disc Brake Kit Compatibility with UFP DB-42 Axle
- Q&A: Diameter of Spindle Washer # SW1000 and Wobble Roller Retainer Ring CE10981
- Q&A: How to Choose the Correct Size Trailer Winch For a Boat Trailer
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Will Installing Trailer Hitch on 2020 Nissan Murano Keep Hands Free Liftgate From Working
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Troubleshooting Trailer Bearings that Fit Almost Too Tight to Install
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
Jameson C.
8/15/2025
Hey Sherrill, did you have a chance to pull a hub and find the bearing numbers or spindle dimensions? If you’re still looking for a solution, I’m happy to help!