Replacement for TDE LP8000 Brake Actuator
Updated 08/15/2025 | Published 07/18/2025
Products Featured in This Question
Question:
I have a Tie Down Engineering LP8000 actuator that needs replacement. The LP8000 housing is welded to my trailer. Are there any actuators that will slide into the LP8000 housing? Or must I have the LP8000 cut off the trailer tongue? Thanks
asked by: Rick S
(click to enlarge)
(click to enlarge)
Expert Reply:
Hey Rick! I'm sorry to say there are no replacement parts that will fit the old actuator. Any inner member or other parts from other brands wouldn't line up correctly in that housing for an easy swap. The only solution is to remove it and install a new brake actuator like the Demco Hydraulic Brake Actuator w/ Drop - Disc # DM8669113.
It is probably worth looking around to see if there are any parts or rebuild kits still floating around out there first since cutting that off and replacing it may also require adding to your tongue based on the space you have available there. Some people opt to cut that off and then add a coupler hinge kit like # FHDPB230101 to extend the tongue back out with stock steel so they can avoid welding.
Product Page this Question was Asked From
Demco Hydraulic Brake Actuator w/ Drop - Disc - Zinc - 2" Ball - 8,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Farm Trailer
- Boat Trailer
- Construction Trailer
- Travel Trailer
- Utility Trailer
- Bolt-On
- 8000 lbs GTW
- 2 Inch Ball Coupler
- 3 Inch Channel Tongue
- Disc Brakes
- No Lockout
- Demco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement for a TDE LP8500 Boat Trailer Acuator
- Q&A: Recommended Replacement for Tie Down Engineering (TDE) Brake Actuator 48980
- Q&A: Replacement Inner Member for TDE LP8500 Actuator
- Q&A: Replacement Actuator for Tie Down TDE LP8000
- Q&A: Can You Convert Tie Down Engineering LP8500 from Disc to Drum
- Q&A: Looking For A Demco DA86 Actuator For Drum Brakes Specifically
- Q&A: Troubleshooting Blown Vehicle Fuses Every Time Trailer is Connected
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Roadmaster Vehicle Specific Base Plates
Robin H.
8/15/2025
Hey Rick, did you find a solution for replacing the LP8000 actuator on your trailer? I'm curious if you decided to cut it off and try the new brake actuator or if you found any parts or kits to rebuild it. Your experience could really help others facing the same challenge!