Replacement Latch and T-Handle for a Southco 92-50-115-10
Updated 08/11/2025 | Published 07/11/2025
Products Featured in This Question
Question:
Hi, will this work as a replacement for the Southco 92-50-115-10 Can Latch T-Handle? Does it come with the backing plate? My existing screw holes are approximately 1 1/2 “ apart. Thanks
asked by: Darren B
(click to enlarge)
(click to enlarge)
Expert Reply:
Hey Darren, thanks for the pictures and measurements. The Camco Replacement Locking T-Handle item # CAM44393 is going to be a closer match to your Southco 92-50-115-10 than the Locking T-Shaped Handle item # 37210885.
The Camco item # CAM44393 has a 2-1/4" Long x 5/16" square shaft and mounting holes 1-1/2" apart. This T-handle does not have the indention in the shaft like yours does so you will need to modify it. It does not come with a backing plate so I recommend reusing the old one.
What kind of trailer or motorhome is this on?
Product Page this Question was Asked From
Locking T-Shaped Handle - 3-3/4" Long - Chrome
- Accessories and Parts
- ATV-UTV Tool Box
- Trailer Tongue Box
- Trailer Tool Box
- Truck Tool Box
- Underbody Tool Box
- Handles and Latches
- T-Handle Latch
- JR Products
more information >
Continue Researching
- Q&A: How Much Does The Meyer HomePlow Residential Hydraulic Snowplow ME33FR Weigh?
- Q&A: Do Meyer Snow Plows Require Lots Of Hardwiring In Truck? What About Wireless Options?
- Q&A: Will the Baby Moon Center Cap Fit a 15 Inch Wheel on a 1938 Chevy Master Deluxe
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Are Furrion Chill The Cube AC Units Worth the Hype
- Q&A: Replacement For PD4560WI Converter
- Q&A: What Gauge Wire Is Needed for Everchill RV Refrigerator w/ Freezer
- Article: In the Market for a Teardrop Camper? You'll Want to Pay a Visit to Hyk Outdoors
- Q&A: 7-Way Trailer Connector Harness for 2008 Nissan Pathfinder With Existing 4-Pole Connector
- Article: How to Measure for Trailer Hitch Drop
Jerred H.
8/7/2025
Hey Darren, how did the Camco Replacement T-Handle work out for your project? I'm curious to know if modifying the shaft was manageable for you. Let me know how it went, as it could really help others facing a similar situation!