Looking For New Hangers And Springs For 2011 Karavan Trailer
Updated 09/08/2025 | Published 06/09/2025
Products Featured in This Question
Question:
I have a circa 2011 karavan double position pwc trailer and need new hangers and springs. Trailer has a 2” square axle. Current hangers are bolted on. Looking for recommendations and guidance. Existing springs are 3 leaf 26.25” long single hook type.
asked by: Andy R
Expert Reply:
Hello Andy, thanks for reaching out. We do carry a leaf spring that may work for you, but I will need to know the weight capacity of your axle to make sure the spring is correctly rated for your trailer.
For example, the 4-Leaf Slipper Spring w/ Hook End # SP-230275 is 26-5/8" long and is rated for a 4,000 lb trailer axle. The 3/8" length difference is within acceptable tolerance, so this will be a good option for you as long as your axle is also 4,000 lb rated. Otherwise, the spring could be too soft or too stiff.
As far as the hangers, we do want to try to match the current hanger height. Is your trailer a single or tandem axle? Can you measure the height of the current front, rear and center hangers? Measure from the center of the bolt hole to the top of the hanger. If you are needing to replace your equalizer I will need hole-to-hole measurements for that too.
For example, the Single-Axle Trailer Hanger Kit for 2" Slipper Springs # APS6SE comes with 3-3/4" tall front hangers and 5-5/16" tall rear hangers.
Reply on this page with those measurements and I am happy to look into it.
Product Page this Question was Asked From
Single-Axle Trailer Hanger Kit for 2" Slipper Springs - 3-3/4" Tall Front
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- Single Axle
- etrailer
more information >
Continue Researching
- Q&A: Does Roadmaster Make the Long U-Bolt Kit part # RM33KT
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Replacement Leaf Spring Bushings for 1-3/4 inch Springs and 2 Inch Hangers
- Q&A: Are Dexter and Kodiak Disc Brake Line Kits the Same in Terms of Quality
- Q&A: Dimensions of Hangers Included with Single-Axle Trailer Hanger Kit for 2" Slipper Springs APS6SE
- Q&A: Upgrading Tire Size and Suspension on a Homemade Hovercraft Trailer
- Q&A: Choosing a U-bolt Kit for Trailer with 1-3/4 Inch Wide Leaf Springs
- Q&A: Recommended Equalizer w/ a 6-1/4" Center Bolt to Center Bolt Spacing
- Article: Double-Eye Trailer Suspension System Review
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: What Is A Leaf Spring? (Everything You Need to Know About Trailer Leaf Suspension)
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How Long will the Axles Last on my Boat Trailer?
Jesse M.
9/8/2025
Hey Andy, did you have a chance to find out the weight capacity of your axle and measure the hanger heights? I'm here to help you find the right parts for your trailer.