Will I Need to Remove My Nerf Bars to Install the MORryde Jerry Can Mount on My 1994 Jeep YJ?
Updated 09/12/2025 | Published 05/26/2025
Question:
i need ti know if it is nessary to remove the nerf bars from my 1994 wrangler YJ to install MORryde jerry can mount MR69MR ?
asked by: Randy B
Expert Reply:
Hello Randy,
That is a pretty sweet Jeep you have! What color is it?
It will depend on how long your nerf bars are. The MORryde Jerry Can Mount for Jeep Wrangler TJ and YJ - Driver or Passenger Side # MR69MR installs pretty close to the front wheel well. I attached an image of how it looks when it is installed, and also where it attaches under the car, you will have to go out and see if it will work.
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
MORryde Jerry Can Mount for Jeep Wrangler TJ and YJ - Driver or Passenger Side
- Jeep Storage
- Cargo Mounts
- Jerry Can Holder
- 18 Inch Tall
- Steel
- TJ
- YJ
- 14-1/2 Inch Wide
- 23 Inch Long
- Black
- MORryde
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What Parts are Needed to Use the Go Power SAE Plug On the Side of My RV?
- Q&A: Will MORryde Jerry Can Mount Also Fit 2" Trailer Hitch Receiver
- Q&A: Can MORryde Jerry Can Mount be Mounted to OEM Hitch Receiver on a 2021 Jeep Grand Cherokee
- Q&A: Roof Rack Recommendation for a 2023 Coleman Rubicon 1400BH Camper
- Q&A: Can The Fender Mounted Jerry Can Holder Be Used On A 2" Receiver?
- Q&A: Could Fender Mounted Jerry Can Holder for Jeep Wrangler MR69MR Attach to Hitch Directly
- Q&A: Can MORryde Jerry Can Mount be Installed on Swing-Away Arm
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Hitch Mounted Cargo Carrier Information
Kate F.
9/12/2025
Hey Randy, did you have a chance to check if your nerf bars would allow for the installation of the Jerry Can Mount? I'm asking because your experience could help others with a similar setup.