Installing Firestone Coil-Rite Air Springs on a 2023 Toyota Sequoia
Updated 05/27/2025 | Published 05/25/2025 >
Question:
Im trying to install the coil rite and it doesnt seem to line up with my vehicle. 2023 toyota sequioa captstone. I can remove the bottom layers but the top is a hard plastic.
asked by: Roy M
Expert Reply:
Not sure what layers you're trying to remove but to install the Firestone Coil-Rite Air Helper Springs item # F4124 you shouldn't have to take them apart. You will however need to remove the coil springs and factory bump stops on your 2023 Toyota Sequoia.
I have attached a couple pictures below of this section of the installation process. Not sure where you having issues but these do install completely different than every other set I have seen. You actually have to disassemble your rear suspension and modify it with a saw to get the air bags in place.
Product Page this Question was Asked From
Firestone Coil-Rite Air Helper Springs - Rear Axle
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Light Duty
- Rear Axle Suspension Enhancement
- Firestone
more information >
Continue Researching
- Q&A: Best Air Bag Kit For 2024 Toyota Sequoia TRD Pro
- Q&A: Hitch Recommendation For A 2026 Honda Accord Hybrid Touring Model
- Q&A: Dimensions of the Top Rail Trim for Enclosed Trailers
- Q&A: Rear Suspension Enhancement Kit that Fits 2024 Toyota Tacoma 4WD
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Q&A: Is There Trailer Hitch that Fits 2024 Honda Accord Hybrid
- Q&A: Correct Air Lift 5000 Kit for a 2016 Toyota Sequoia SR-5
- Q&A: Will Air Bags Help w/ Towing and Leveling on a 2023 Toyota Sequioa?
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Galvanized vs. Aluminum Trailers
- Article: How Much Does a Boat and Trailer Weigh?
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?




Roy
5/27/2025
Im trying to send you a picture of the coil spring dampner which has two parts. the bottom is thick coned shaped rubber and the top part is a hard plastic.