What Would Cause a Pal Nut to Fall Off of Roller Shaft of Keel Roller
Updated 09/26/2025 | Published 04/27/2025
Products Featured in This Question
Question:
I have a keel roller where the end cap came off presumably from vibration and the keel roller got pushed down and wedged in the bracket lucky, as it saved the hull from getting gouged by the bracket. Is that likely from vibration? Is there anything I should do to stop that? Maybe a shaft that has a cotter pin, or a lock nut? I dont see anything like that on the website, but maybe I missed it.
asked by: Peter E
Expert Reply:
Hey Peter, generally the pal nuts on the end of the roller shafts hold the shaft tight enough that they don't just pop off unless something possibly hit it and damaged it. Vibration is not known to allow them to pop off so I would assume this is more of a fluke situation than anything else.
For replacement pal nuts we have the part # CE10800 for a 1/2 inch diameter shaft or the part # CE10801 for 5/8 inch diameter.
Product Page this Question was Asked From
Replacement Cap Nut - Zinc - 1/2" - Qty. 1
- Accessories and Parts
- Boat Trailer Parts
- Hardware
- 1/2 Inch Diameter
- Nuts
- Cap Nut
- CE Smith
more information >
Continue Researching
- Q&A: Brake Controller Install on 1997 Chevrolet Pickup
- Q&A: Recommended Guide to Center 1850 Lund Impact on Shorelander Boat Trailer
- Q&A: Interior Dimensions of the UWS Cargo Carrier for 2" Hitches
- Q&A: How to Determine What Size Wobble Rollers are Needed to Replace Boat Trailer Rollers
- Q&A: Should Boat Trailer Roller Shafts be Greased
- Q&A: Pal Nut Removal Instructions
- Q&A: How to Install Pal Nuts on a Roller Shaft
Jameson C.
9/26/2025
Hey Peter, did you find a solution to keep your keel roller secure? I'm asking because your experience could help others facing a similar issue.