Looking For Replacement Outer Bearing For 2008 Holmes 18' Trailer
Updated 04/17/2025 | Published 04/05/2025
Question:
I have a 2008 Holmes 18 foot dual axle trailer, 10k weight capacity and I need the outer bearing replaced. The inside diameter is 1 1/4”. I purchased one but the od is smaller than the current one. It looks like the od on it is 5.53cm or 2.23 inches or 2 3/16. I used a caliper but new to reading those. Is this the correct bearing?
asked by: Matthew B
Expert Reply:
Hello Matthew, thanks for reaching out. The # LM67048 bearing does have a 1.250" ID. This bearing goes with the # LM67010 race which has a 2.328" OD and the ID is like 2.15". So it sounds like the # LM67048 may not be correct for you.
Is there a number you can see stamped on your bearing? Getting the number may help to cross reference and find what you need. If your axle uses an uncommon/obsolete bearing size, the next thing we would look at is doing new hubs, or potentially a whole new axle.
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - LM67048
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.25 Inch I.D.
- Bearing LM67048
- Race LM67010
- 5000 lbs Axle
- 6000 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: Do I Have to Use Timken Races with Timken Bearings, or can I Use Mine that were Made in China?
- Q&A: Replacement Bearings For A 6,000 Pound Dexter Axle
- Article: Trailer Wiring Diagrams
- Q&A: Comparing Chinese Bearings with Bearings Made in the USA
- Q&A: Best Way To Carry One (Or Two) Kayaks On A 2024 Subaru Outback
- Q&A: Replacement Hubs and Brakes for Axle Tecknology BD2-655 Drums
- Q&A: Should I Carry A Spare Leaf Spring For The Roadmaster Comfort Ride Suspension System?
- Q&A: Replacement Components for a Dexter 5100 Pound Axle
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
Matthew B.
4/8/2025
Hey Jesse. Unfortunately there isn’t anything stamped on the bearings. That would have made this much easier for me. Appreciate the response