Looking For Disc Brake Conversion For 2001 A/M Tandem Axle Trailer
Updated 10/27/2025 | Published 03/09/2025
Products Featured in This Question
Question:
2001 V\M tandem trailer loaded with a Centurion 22’ v-Drive. Surge hydraulic drums on 1 axle. I don’t know the actual axle sizes. I’ve enclosed the trailer vin plate. Can you recommend a disc conversion kit, and replacement hubs for the idle axle? Rob
asked by: Rob M
(click to enlarge)
Expert Reply:
Hey Rob, thanks for reaching out. We may have disc brake conversion parts for you, but I will need to gather a bit more information from you.
You will need to replace your actuator with one that is disc brake compatible like the Demco # DM62VR.
Since this trailer is older you will need to remove a hub and pull the bearings to determine the correct hubs. Each bearing will have a number stamped on the edge, or you can measure the ID with a micrometer. Also measure the ID of your seal and your hub bolt pattern. There is no way to use the VIN to look up this info unfortunately.
Drop that info in a comment below and I am happy to look into it and recommend parts
Product Page this Question was Asked From
DeeMaxx Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Maxx Coating - 3,500 lbs
- Trailer Brakes
- Disc Brakes
- Marine Grade
- 5 on 4-1/2 Inch
- Hub and Rotor
- 1/2 Inch Studs
- 3500 lbs Axle
- 14 Inch Wheel
- DeeMaxx
more information >
Continue Researching
- Q&A: Recommended Replacement 10" Disc Brake Kit for a Coyote Trailer for Saltwater Application
- Article: Most Popular Wheel Bearings
- Q&A: What is Difference Between Kodaguard and Dacromet Coated 3,500 lb Kodiak Disc Brake Kits
- Q&A: Disc Brake Kit Recommendation for 3,500 lb Axle and 5 on 4-1/2" Bolt Pattern Idler Hub
- Q&A: Can the DeeMaxx Disc Brake Assembly Be Purchased as a Single Unit Instead of a Pair?
- Q&A: Replacing Knott Brand Brake Calipers And Rotors On A Coyote Boat Trailer With 3,500 lb Axles
- Q&A: Solution for Needing Replacement Disc Brake Componentts for Venture Boat Trailer # VATB-5225
- Q&A: Recommended Electric Over Hydraulic Conversion Kit for a Boat Trailer w/ 3,500 lbs Axles
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Trailer Wiring Diagrams
Jesse M.
10/27/2025
Hey Rob, were you able to pull the bearings and get those measurements from your trailer hubs? Once you have that info, I can help narrow down the right disc conversion kit and replacement hubs. Let me know what you find so we can get you set up.