Does it Matter what Side I Install Side A and Side B on the Timbren Silent Ride Suspension?
Updated 10/30/2025 | Published 02/13/2025 >
Question:
Does it matter whatcha side A and B is on ? On the to been silent ride
asked by: Karl
0
Expert Reply:
Hello Karl,
On the Timbren Silent Ride Suspension for Tandem Axle Trailers w/ 3" Round Axles - 14,000 lbs # TSR14KT01 it does not matter what side you install side A and side B, that only matters on the single axle set ups.
What kind of trailer are you putting these on?
expert reply by:
Kate F
0
Product Page this Question was Asked From
Timbren Silent Ride Suspension for Tandem Axle Trailers w/ 3" Round Axles - 14,000 lbs
- Trailer Suspension Parts
- Leaf Spring Replacement System
- Camper
- Car Hauler
- Utility Trailer
- 14000 lbs
- Round Axle - 3 Inch
- Tandem Axle
- Timbren
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Best Suspension Enhancement For Grand Design Trailer With 3,500 lb Axles on Rough Roads
- Q&A: Is There a Downside to Using Offset Gooseneck Ball Compared to Non-Offset
- Q&A: Best Suspension Upgrade for 33" Tandem Axles: Road Armor vs Dexter EZ Flex for Ember 22ETS
- Q&A: Lippert Center Point Trailer Air-Ride Suspension Upgrade Kit LC1565391
- Q&A: Recommended 3" Gooseneck Ball for Factory Prep Packages
- Q&A: Wall Thickness of Demco Gooseneck Coupler Outer Tube part # DM63KV
- Q&A: Determining Correct Length Replacement Leaf Spring
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Where to Position the Trailer Axle?
- Article: Slipper Spring Trailer Suspension System Review
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Raise Your Travel Trailer Height



Kate F.
10/30/2025
Hey Karl, how did things go with the Timbren Silent Ride suspension on your trailer? Did the setup go smoothly once you knew the sides didn’t matter for the tandem axle? Your update could make it easier for the next person working on the same suspension.