Clearance Light With Wires Running Out From Center
Updated 01/15/2025 | Published 01/03/2025 >
Question:
Hello. I was wondering if I would be able to drill a small hole into the center where it’s marked on the photo to reroute the wires? My camper/original light has a small center hole where the wire comes out from the light into the camper. Is that ok or would you recommend another part number. Thank you.
asked by: Manny
Expert Reply:
Hi Manny; you can drill a hold in the center of the # MC44RB to run the wires. There isn't a lot to the light inside the lens/housing so you won't damage a circuit board or anything like that by drilling. The other option would be to use the # MC32RB but you may have to enlarge your opening on the trailer for that plug to fit and sit flush.
Product Page this Question was Asked From
Optronics Trailer Clearance or Side Marker Light w/ Reflex Reflector - Incandescent - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 4L x 1-1/2W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Correct Replacement for Glo Brite Marker Lights 118A and 117R
- Q&A: GloBrite 126R/126Y Red Replacement Light
- Q&A: Replacement Trailer Clearance Lights for Bargman 99 Series
- Q&A: Replacement Clearance or Side Marker Light for a 20321-02 Light
- Q&A: Replacement Lenses and Lights for Glo-Brite 118A/117R
- Q&A: Electric Tongue Jack for 7,000 lb Cargo Trailer
- Q&A: Replacement Trailer Light for a Reflect-O-Lite 270
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: RV Pre-Departure Checklist
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers




Manny
1/15/2025
Hello Robin. Sorry for the delay in replying to your answer. Thank you very much for the stating that I am able to drill the hole. That’s exactly what I needed to know!