Solera RV Slide-Out Awning Size Needed For A 7' Flange-To-Flange Measurement
Updated 11/17/2025 | Published 12/13/2024
Products Featured in This Question
Question:
What size do I need if I measure 7 feet from flange to flange?
asked by: Fred
Expert Reply:
Hey Fred,
For a 7' length you'd need Solera's # LCV000163287 (white) or # LCV000165062 (black). The arms for this should stick out about 3" on each side but could potentially stick out a bit more. Doublecheck that there's not a window, vent, accessory, etc. that could interfere with them.
For the installation you'll also need some butyl tape # AL28FJ to waterproof the mounting screws for the awning brackets. I've attached a video below where Brad will walk you through the installation process.
Product Page this Question was Asked From
Solera RV Slide-Out Awning - 85" Wide - White
- RV Awnings
- Slide-Out Awnings
- Extends 48 Inches
- 7 Feet Wide
- 80 Inch Wide
- 81 Inch Wide
- 82 Inch Wide
- 83 Inch Wide
- 84 Inch Wide
- 85 Inch Wide
- White
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Determining the Correct Solar Panel Kit for Off-Grid Use
- Q&A: Will Go Power Overlander Expansion Kit Work With 30 Amp Controller
- Q&A: Recommended Slide Topper for a 82-1/2" Slide Out
- Q&A: How To Select The Right Awning Size For Slideout
- Q&A: Clearance Above Slide-Out Needed for Installing Slide Topper
- Q&A: How to Convert Dometic RV AC Unit to Furrion Chill HE Unit
- Q&A: Installing Slide Topper Awning With Regular Awning Attached To Slide
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Gooseneck to 5th Wheel Adapters
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Best Bike Racks for Electric Bikes
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Carry Bikes While Towing a Travel Trailer
Jesse M.
11/17/2025
Hey Fred, how did the 7-foot Solera slide-out awning work out for your setup? Your update could make it easier for the next person measuring a similar flange-to-flange width.