Center Hanger Recommendation to Replace a 5 inch Tall Hanger
Published 06/03/2014
Products Featured in This Question
Question:
The center hanger on my travel trailer is 5inch centerline to the top of the bracket. The on 5inch hanger i see is 5 7/16 part # 115919. How will this affect the suspension? And will a wet bolt fit to hold the equalizer in.
asked by: Mike
0
Expert Reply:
Having the centerline of the hanger sit 7/16 of an inch lower than what you have now will now cause any adverse trailer handling conditions. It would be totally fine.
Also, a wet bolt would work great for you would be the Wet Equalizer Bolt with Castle Nut # 126A1.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Center Hanger for Double-Eye Springs - 5-7/16" Tall - 3/4" Bolt Hole
- Trailer Suspension Parts
- Hangers
- Camper
- Car Hauler
- Utility Trailer
- Double Eye Springs
- 3/4 Inch Diameter
- 5-7/16 Inch Tall
- Tandem Axle
- Triple Axle
- Redline
more information >
Continue Researching
- Q&A: Replacement 6 Leaf Leaf Spring for a Dexter 7,000 lbs Axle
- Q&A: Can I Use a 6-Ton Jack to Change the Tire on a 16,000 lbs Motorhome?
- Q&A: Equalizer Replacement Options for Dexter 13-122 Equalizer
- Q&A: Replacement Parts Available for the RAM Trailer Jack Part # TJD-7000S
- Q&A: How Do I Measure Axle Spread for Upgrading The Trailer Equalizers?
- Q&A: Correct Dexter Heavy-Duty Suspension Kit for a 2002 Ranger Boat Trailer With 7-3/4" Equalizer
- Q&A: What Direction Should The Band on a Leaf Springs Be Faceing
- Article: Where to Position the Trailer Axle?
- Article: Trailer Wiring Diagrams
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Raise Your Travel Trailer Height
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Double-Eye Trailer Suspension System Review