Do 2019 GMC Sierra 2500 Roadmaster Anti-Sway Bar End Links have a Torque Spec
Updated 12/15/2025 | Published 11/15/2024
Question:
I just installed this roadmaster bar on my 2019 Sierra 2500 HD. I was surprised to find the instructions did not have torque values for the bolts among other things in these, the worst directions I have ever seen this side of china. Common practice is to leave these bolts snug and then torque to spec with the vehicle on the ground? Can you please advise?
asked by: Bill H
Expert Reply:
Hey Bill,
The end links on your Roadmaster Rear Anti-Sway Bar # RM-1109-169 will need to be snugged up and then turned another 1/8 to 1/4 turn. There aren't any torque specs for these which is why you didn't see anything in the instructions, although I do agree that Roadmaster could be a bit more clear on this in their instructions.
I confirmed all of this with my contact at Roadmaster.
Product Page this Question was Asked From
Roadmaster Rear Anti-Sway Bar - 1-1/4" Diameter
- Anti-Sway Bars
- Anti-Sway Bar
- Rear
- 1-1/4 Inch Diameter
- Fixed End Link
- No Drilling Required
- Mounting Hardware Included
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Compatible Sway Bar for a 2018 GMC Sierra 2500 w/ a Air Bag Kit
- Q&A: TorkLift StableLoad Suspension Upgrade For A 2020 Chevy Colorado ZR2
- Q&A: TorkLift StableLoad Kit for a 2017 Chevy Silverado 2500 4x4
- Q&A: What TorkLift Tie Downs do I Need for My 2022 F-350, and What are the Weights?
- Q&A: Suspension Enhancement When Adding a 3,500LB Slide In Camper To a 2019 Chevrolet Silverado 3500HD
- Q&A: Comparing Roadmaster and Hellwig Sway Bars for Motorhome Built on E-450 Chassis
- Q&A: Hellwig Rear Sway Bar For 2016 GMC Sierra 3500HD With 4" Lift
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Stability Control for Heavy Duty Vehicles
Jameson C.
12/15/2025
Hey Bill, how did things turn out after snugging and giving the end links that extra 1/8 to 1/4 turn on your Sierra’s Roadmaster sway bar? Did that tighten everything up the way you expected? Your feedback could really help others setting up the same bar.