Availability of Replacement 2-3/4" Shackle Bolt

Question

Question:

I found you have a shackle bolt Shackle Bolt For Double-Eye Springs - 9/16 Diameter - Plain - 3 Long However, the shackle bolts on my RV trailer are 2 3/4. Do you sell that product?

asked by: Fred R

0

Expert Reply:

Hi Fred; the closest we have to 2-3/4" is the Dexter Shackle Bolt for Double Eye Springs - 9/16" Diameter - 2-7/8" Long # 007-126-01. If you didn't take a precise measurement this may match up so it would be worth check to see if it is actually 2-7/8".

expert reply by: Robin H

0

Fred R.

11/14/2024

OK. Thanks. Will Locknuts (Part no: TRFA916DLNZ) work with shackle bolts (part no: 007-003-01)? They are shown below. I just want to make sure. Fred Rodriguez

Robin H.

11/14/2024

@FredR yes the # TRFA916DLNZ will fit the # 007-003-01

Answer 1

Hi Steven; take a look at the diagram below. Since your springs wear out over time it is best to use measurement D and E and match what is on your trailer. For the 4-Leaf Slipper Spring w/ Radius End for 2,000-lb Trailer Axles #e69SR D is 12"…

view full answer...

Answer 2

Hey Dave, thanks for reaching out! It looks like our 24-5/8" Long 3-Leaf Slipper Spring #e99SR is going to be the best replacement for your setup. This comes with a nylon bushing (which is standard) in that eyelet, so you actually won't need…

view full answer...

Answer 3

The best slipper spring option for your Triton PWC trailer is going to be the Slipper Spring part #SP-039275 as it's for up to a 2,900 lb axle, is a 3-leaf setup, and is 1-3/4 inches wide. It does have a flat end though and not a radiused end but…

view full answer...

Answer 4

It looks like the springs that you have are the 4-Leaf Double-Eye Spring for 3,500-lb Trailer Axles #SP-210275. These springs do not have a lot of curve built into them at 2-3/4" when relaxed from eylet to top of spring pack. There are some…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hey Ian, great to hear from you again! The differences between the MORryde CRE3000 #MR87ZR and AllTrek 4000 #MR89DR that fit a 33" wheelbase is the height between the hanger and equalizer bolts, and the amount of travel the suspension style will…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Availability of Replacement 2-3/4" Shackle Bolt

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching